TYAN TIGER 100 Manual page 24

Chapter 2
Board Installation
To attach the retention module, place
the motherboard on a flat surface.
Locate the key pin on one end of the
Pentium II slot on the board. Then
carefully line up the key notch on the
retention module with the key pin on
the Pentium II slot (the key pin on
the Pentium II slot indicates the
correct orientation of the CPU) See
Figure 2-8.
Figure 2-9
Installing the CPU with Active Cooling
When the retention module is securely installed, you are
ready to plug in the CPU. Press down firmly on the CPU until
you hear a "click" (see Figure 2-10). This clicking sound
indicates that the CPU is fully locked into the retention
module. If you have an active cooler, you will also need to
connect the CPU's cooling fan cable to the cooling fan power
connector on the board.
Locate the cooling fan connector (e.g. FAN1) on the mother-
board. Plug the CPU's cooling fan cable into the cooling fan
connector on the board. There will be a plastic clip assembly
similar to that of the ATX power connector that will force you to connect the
fan cable correctly (see Figure 2-11 on the following page).
Figure 2-8 - Pentium II Slot Connec-
tor and Key Pin
Drop the retention module (Figure 2-9) down
over the Pentium II slot so that the retention
module sits flat against the motherboard. Tighten
the screws in a clockwise manner to secure the
module to the board. Warning: Do not over-
tighten the screws as you may damage the
module and/or the motherboard.
24
Figure 2-10
http://www.tyan.com