Table of Contents
Advertisement
Chapter 2: Board Installation
Precautions: The Thunder h1000E / Tomcat h1000E supports SSI, EPS12V
type power supplies (24pin + 8pin) and will not operate with any other types.
For proper power supply installation procedures see page 34.
DO NOT USE ATX 2.x or ATXGES power supplies as they will damage the
board and void your warranty.
How to install our products right... the first time
The first thing you should do is reading this user' s manual. It contains important
information that will make configuration and setup much easier. Here are some
precautions you should take when installing your motherboard:
(1) Ground yourself properly before removing your motherboard from the
antistatic bag. Unplug the power from your computer power supply and
then touch a safely grounded object to release static charge (i.e. power
supply case). For the safest conditions, TYAN recommends wearing a
static safety wrist strap.
(2) Hold the motherboard by its edges and do not touch the bottom of the
board, or flex the board in any way.
(3) Avoid touching the motherboard components, IC chips, connectors,
memory modules, and leads.
(4) Place the motherboard on a grounded antistatic surface or on the
antistatic bag that the board was shipped in.
(5) Inspect the board for damage.
The following pages include details on how to install your motherboard into your
chassis, as well as installing the processor, memory, disk drives and cables.
DO NOT APPLY POWER TO THE BOARD IF IT HAS BEEN
NOTE
DAMAGED.
7
http://www.tyan.com
Advertisement
Table of Contents
