TYAN THUNDER K8SE Manual page 39

Hammer Configuration
Integrated Devices
PCI Configuration
IDE Configuration
Floppy Configuration
I/O Device Configuration
Hardware Monitor
Console Redirection
3.6.1 – Hammer Configuration Sub-Menu
You can use this screen to select options for the Hammer Configuration
settings. Use the up and down <Arrow> keys to select an item. Use the <Plus>
and <Minus> keys to change the value of the selected option.
Advanced
Hammer Configuration
Memhole mapping
HT-LDT Frequency:
MTRR Mapping Method:
Bank Interleave:
Node Memory Interleave:
ECC:
ECC Scrub Redirection
4-bit ECC:
DCACHE ECC Scrub CTL:
L2 ECC Scrub CTL:
Dram ECC Scrub CTL:
F1: Help ¡ ô ¡ õ : Select Item
Esc: Exit ¡ ö ¡ ÷ : Select Menu Enter: Select
F10: Save and Exit
Menu Item Set Hammer Configuration
Menu Item Set integrated devices
Menu Item
Configure PCI devices
Menu Item
Configure IDE interface
Menu Item
Configure floppy interface
Menu Item Peripheral configuration
Menu Item
Configure Hardware Monitor
Additional setup menus to
Menu Item
configure console
PhoenixBIOS Setup Utility
[Hardware]
[800Mhz]
[Continuous]
[Auto]
[Disabled]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[1.31 ms]
-/+: Change Values
Sub-Menu
39
http://www.tyan.com
Item Specific Help
F9: Setup Defaults