Installing The Power Supply - TYAN THUNDER K8SD PRO Manual

10Mbps
Activity
10Mbps
Left Right
100Mbps
Activity
100Mbps
1000Mbps
Activity
1000Mbps
2.39 – Installing the Power Supply
There are t w o power connectors on your Thunder K8SD Pro S2882-D. The Thunder
K8SD Pro S2882-D requires that you have an EPS12V power supply that has a 24-pin
and an 8-pin power connector. Please be aware that ATX 2.x, ATX12V and ATXGES
power supplies are not compatible with the board and can damage the motherboard
and/or CPU(s).
Disconnect power supply from electrical outlet
1. Connect the EP12V 8-pin power connector
2. Connect the EP12V 24-pin power connector
3. Connect power cable to power supply to power outlet
Make sure you have connected both connectors before attempting to apply power
to the board.
YOU MUST unplug the power supply before plugging the power cables to
NOTE
motherboard connectors.
10/100/1000 Mbps LAN Link/Activity LED Scheme
Speed
Link
Green (Blink)
Link
Link
Green (Blink)
http://www.TYAN.com
Left LED
Green
Off
Off
Green
36
Right LED
Off
Off
Yellow
Yellow (Blink)
Yellow
Yellow (Blink)