Finishing Up - TYAN THUNDER K8QSD PRO Manual

Power Supply Connection Matrix (w/ 2-rank memory)
Model # Connector on EPS12V PWR Supply
# 1
Power Supply Connection Matrix (w/ 4-rank memory)
Model # Connector on EPS12V PWR Supply
# 1
Disconnect power supply from electrical outlet
a. Connect the EPS12V 8-pin power connectors
b. Connect the EPS12V 24-pin power connector
c. Connect power cable to power supply to power outlet
Make sure you have connected both connectors before attempting to apply
power to the board.
* w/ 4-rank memory: please connect total 5 power connectors before connect power
cable to power supply to power outlet.
NOTE: We suggest using a 700W or higher power supply; this is dependent on how
many devices you have installed. However, 700W is sufficient for system without
many devices (i.e. 4 x AMD Opteron 875 CPU, 16 x 1G DDR 333 Memory, 1 x HDD,
2 or 3 expansion cards). For 4-rank memory support, please contact Tyan directly
for related power consumption table.
2.31 – Finishing Up
Congratulations on making it this far! You're finished setting up the hardware aspect
of your computer. Before closing up your chassis, make sure that all cables and wires
are connected properly, especially IDE cables and most importantly, jumpers. You
may have difficulty powering on your system if the motherboard jumpers are not set
correctly.
In the rare circumstance that you have experienced difficulty, you can find help by
asking your vendor for assistance. If they are not available for assistance, please find
setup information and documentation online at our website or by calling your vendor's
support line.
24-pin Connector
8-pin Connector
8-pin Connector
24-pin Connector
8-pin Connector
8-pin Connector
4-pin Connector
4-pin Connector
http://www.TYAN.com
MB Power Connector
J29: 24-pin EPS 12V Connector
J63: 8-pin EPS12V Connector
J25: 8-pin EPS12V Connector
MB Power Connector
J29: 24-pin EPS 12V Connector
J63: 8-pin EPS12V Connector
J25: 8-pin EPS12V Connector
J89: 2x2 pin ATX12V Connector
J90: 1x4 pin 5V Connector
35