2.04 – Clear CMOS Jumper (J8)
2.05 – SMBus Connector (J11)
Pin_3
Pin_3
You can reset the CMOS settings by
using this jumper if you have forgotten
your system/setup password or need to
clear system BIOS setting.
-
Power off system and disconnect
both power connectors from the
motherboard
Use jumper cap to close Pin_2 and
-
Pin_3 for several seconds to Clear
CMOS
-
Put jumper cap back to Pin_1 and
Pin_2 (default setting)
Reconnect power & power on system
Pin_1
Pin_1:
SMBUSD_0
Use this connector to connect external
SMBUS devices
13
http://www.TYAN.com
Default
Pin_1
Clear
Pin_1
Pin_2:
Pin_3:
GND
SMBUSC_0
Pin_4
: NC