TYAN THUNDER K7 User Manual page 39

(advanced setup, continued)
Mode
Base I/O
Interrupt
Parallel Port
Mode
Base I/O
Interrupt
Thunder K7 S2462
FORMAT: [option]
OPTIONS: IR
Normal
NOTES: This option is only for Serial Port B.
FORMAT: [option]
OPTIONS: 3F8, 2F8
3E8, 2E8
NOTES: Recommended combinations include '3F8,
IRQ4' and '2F8, IRQ3'.
FORMAT: [option]
OPTIONS: IRQ4
IRQ3
NOTES: Recommended combinations include '3F8,
IRQ4' and '2F8, IRQ3'.
FORMAT: [option]
OPTIONS: Disabled
Enabled
Auto
FORMAT: [option]
OPTIONS: Output only
Bi-directional
EPP
ECP
FORMAT: [option]
OPTIONS: 378
278
3BC
FORMAT: [option]
OPTIONS: IRQ5
IRQ7
Selects the mode to use.
IR = Infrared
These options are depen-
dent on the IRQ, and vice
versa.
These IRQs are paired
with the Base I/O option.
'Disabled' turns off the
port.
'Enabled' requires you to
enter the base I/O
address and the INT num-
ber.
'Auto' makes the BIOS
configure the port during
POST.
Standard one-way proto-
col for parallel devices.
Two-way protocol for par-
allel devices.
Enhanced Parallel Port
interface may provide
higher bandwidth, if an
EPP device is used.
Enhanced Capability Port
interface may provide
higher bandwidth, if an
ECP device is used.
These options appear
when the parallel port is
set to 'Enabled'.
These options appear
when the parallel port is
set to 'Enabled'.
39