Slot-B And Slot - C Pci-X/Pci-2.2 Jumper; Clear Cmos Jumper; Acpi Wake-Up Jumper For Usb Port-E ~ F - TYAN THUNDER I7505 Manual

2.9 – Slot- B a nd Slot- C PCI-X/PCI-2.2 Jumper (J31)
2.10– Clear CMOS Jumper (J50)
2.11 – ACPI Wake- up Jumper for USB Port-E and Port-F (J65)
OPEN (Default)
To switch Slot-B, Slot-C and onboard SCSI to
PCI-X compatible mode
CLOSE
To switch Slot-B, Slot-C and onboard SCSI to
PCI-2.2 compatible mode
Clear
You can reset the CMOS settings by using this
jumper when you
§ Have forgotten your system/setup password
§ Need to clear system BIOS setting
- Power off system and disconnect power
supply from AC source
- Use jumper to close JP50 for several
second s to Clear CMOS
- Take off jumper from JP50 (default setting)
- Reconnect power supply to AC source
- Power on system
- Use "F2" key to go into system BIOS setup
CLOSE Pins 1 and 2 (Default)
Front panel USB devices' ACPI S1 wake up
CLOSE Pins 2 and 3
Front panel USB devices' ACPI S1/S4 wake
up
Total current of all USB devices should not exceed the
standby current rating of the power supply
12
http://www.TYAN.com
Default
pin-1
pin-1