Table of Contents
Advertisement
Quick Links
Page 1
SERVICE MANUAL
DXN 100
DXN 200
counter cubelet
Scotsman Ice Srl
Via Lainate, 31 - 20010 Pogliano M.se - Milano - Italy
Tel. +39-02-93960.1 (Aut. Sel.)- Telefax +39-02-93550500
Direct Line to Service & Parts:
Phone +39-02-93960350 - Fax +39-02-93540449
Website: www.scotsman-ice.it
E-Mail: scotsman.europe@scotsman.it
Electronic
ice dispenser
REV. 11/2018
Page 1
Advertisement
Table of Contents
Related Manuals for Scotsman DXN 200
Summary of Contents for Scotsman DXN 200
- Page 1 Page 1 Page 1 SERVICE MANUAL DXN 100 DXN 200 Electronic counter cubelet ice dispenser Scotsman Ice Srl Via Lainate, 31 - 20010 Pogliano M.se - Milano - Italy Tel. +39-02-93960.1 (Aut. Sel.)- Telefax +39-02-93550500 Direct Line to Service & Parts: Phone +39-02-93960350 - Fax +39-02-93540449 Website: www.scotsman-ice.it...
-
Page 2: Table Of Contents
Page 2 Page 2 Table of contents page TABLE OF Specifications DXN 100 CONTENTS Specifications DXN 200 GENERAL INFORMATION AND INSTALLATION Introduction Unpacking and Inspection Location and levelling Electrical connections Water supply and drain connections Final check list OPERATING INSTRUCTIONS... - Page 3 NOTE. The daily ice-making capacity is directly related to the condenser air inlet temperature, water temperature and age of the machine. To keep your SCOTSMAN CUBELET DISPENSER at peak performance levels, periodic maintenance checks must be carried out as indicated on page 22 of this manual.
- Page 4 Page 4 Page 4 SPECIFICATIONS DXN 100 - MACHINE SPECIFICATIONS Ice bin Water req. Model Cond. unit Finish lt/24 HR (*) DXN 100 AS S. Steel 5 Kg 44,5 Start Electric power cons. Basic electr. Amps Watts (*) Nr. of wires...
- Page 5 NOTE. The daily ice-making capacity is directly related to the condenser air inlet temperature, water temperature and age of the machine. To keep your SCOTSMAN CUBELET DISPENSER at peak performance levels, periodic maintenance checks must be carried out as indicated on page 22 of this manual.
- Page 6 Page 6 Page 6 SPECIFICATIONS DXN 200 - MACHINE SPECIFICATIONS Ice bin Water req. Model Cond. unit Finish lt/24 HR (*) DXN 200 AS S. Steel 10 Kg 62,2 Start Electric power cons. Basic electr. Amps Watts Nr. of wires Amps fuse Amps Kwh per 244 Kg...
-
Page 7: General Information And Installation
Forward the completed self-addressed up and operation, maintenance and cleaning for registration card to SCOTSMAN factory. the SCOTSMAN DXN 100 and DXN 200 counter cubelet ice dispensers. Their ice making systems are thoroughly tested C. LOCATION AND LEVELLING providing the utmost in flexibility to fit the needs of a particular user. -
Page 8: Water Supply And Drain Connections
1 bar CONNECT TO POTABLE WATER ONLY (14 psi). DXN 100 - 200 have the possibility to have the water connections through the bottom base or Check all refrigerant lines and conduit lines through the rear bottom side of the machine. -
Page 9: Operating Instructions
Page 9 Page 9 OPERATING INSTRUCTIONS After having correctly installed the ice dispenser OPERATION CHECKS UPON THE UNIT and completed the plumbing and electrical START UP connections, perform the following Start-Up pro cedure Remove service panels and if necessary install the refrigerant service gauges on the corresponding Service valves to check both the START UP HI and LO refrigerant pressures. - Page 10 Page 10 Page 10 After 10 minutes the unit resumes its total • Touchless ( With Optical Dispensing Devices operation with the immediate start-up of the gear installed) motor and, 2 seconds later, of the compressor. The initial setting is already made in factory according with the version of the unit, in case of H.
-
Page 11: Principle Of Operation (How It Works)
Page 11 Page 11 PRINCIPLE OF OPERATION WATER CIRCUIT By running the ice maker, i.e. by putting the unit under power, starts the automatic and continuous The water enter in the machine through the icemaking process which would not stop until the water inlet valve (which incorporates a strainer ice storage bin gets filled-up to the level of the and it is located at the rear side of the cabinet) -
Page 12: Mechanical System
220 gr MECHANICAL SYSTEM NOTE. Before charging the refrigerant system always check the type of refrigerant and The mechanical system of the SCOTSMAN Ice quantity as specified on the individual ice Dispenser consists basically of a gear motor machine dataplate. -
Page 13: Components Description
Page 13 Page 13 COMPONENT DESCRIPTION NOTE. To restart the unit after the shutoff caused by the hi condenser temperature, it is necessary (after having remedied to the A. EVAPORATOR TEMPERATURE causes of unit stoppage) to switch OFF and SENSOR - BLACK 2 POLES CONNECTOR ON the power line main disconnect Switch. - Page 14 Page 14 Page 14 ICE/WATER OPTICAL DISPENSING DEVICES The PC Board of the control panel operates (ONLY FOR TOUCH LESS VERSION) the capacitive keys, LEDs, infrared sensor and the connection with the power PC Board Located on the front of the dispensing area it of the dispenser, managing the dispensing consists of the combination of an infrared mode of ice and water and showing any alarm...
- Page 15 TcL : Touchless Dispensing time 1 up to 15 seconds CON= continuos 3 sec. Machine model 100 = DXN 100 200 = DXN 200 Menu Program Description Display Meaning and reset mode Compressor working hours Shows the current working hours of compressor...
- Page 16 Page 16 Page 16 The three LEDS, placed in a row in the center of function normally. To reset the remind, go into the P.C. BOARD, monitor the following situations: alarm (by pressing the ALARM key for 5‘’) and while displaying the “CLE” condition simply press Green ON/OFF = Power ON or OFF the ALARM button for more than 5‘’.
- Page 17 Page 17 Page 17 Two seal rings, one fitted on the rotor shaft and P. STORAGE BIN the other on the output shaft keep the gear case sealed. Round shaped it is located in the front of the ice Hovewer, the interior can be inspected and machine and has the main reason to store the ice serviced by unbolting the two halves of the produced by the evaporator till it reaches its...
-
Page 18: Wiring Diagram - Dispensing Board Version
Page 18 Page 18 WIRING DIAGRAM - DISPENSING BOARD VERSION AIR AND WATER COOLED 230/50/1... - Page 19 Page 19 Page 19...
-
Page 20: Service Diagnosis
Page 20 Page 20 SERVICE DIAGNOSIS SYMPTON POSSIBLE CAUSE SUGGESTED CORRECTION Unit will not run Blown fuse in P.C.Board Replace fuse & check for cause of No LED lighted-up blown fuse Master switch in OFF position Turn switch to ON position Inoperative P.C.Board Replace P.C.Board Loose electrical connections... - Page 21 Page 21 Page 21 SERVICE DIAGNOSIS SYMPTON POSSIBLE CAUSE SUGGESTED CORRECTION Wet ice Ambinet temperature too high Move unit to cooler location High water level in the freezer Lower to approx. 20 mm below ice spout Faulty compressor Replace Machine runs but makes no ice Water not entering in the freezer Air look in feed line to freezer.
-
Page 22: Maintenance And Cleaning Instructions
C. MONTHLY MAINTENANCE It must be performed by the user of the DXN Dispenser, and consists of cleaning and sanitising the ice bin area. Tools required: Scotsman Sanitizer, gloves, carafe. - Page 23 Remove ice, distribution vane and steel bottom from the storage bin. In a carafe, prepare 500 ml of warm water (40-50°C) and 15 ml of Scotsman Sanitizing product and wait at least 10 minutes.
- Page 24 Make sure that the first produced the help of a bit of SCOTSMAN Cleaner. ice doesn’t taste slightly acid; in any case empty the bin by pressing the dispensing 7.
-
Page 25: Cleaning Instructions Of Water System
7. Prepare the cleaning solution by diluting in a sanitize the interior of the storage bin plastic container two liters of warm water with an anti-algae disinfectant solution (45°- 50°C) with a 0,2 liters of SCOTSMAN every once or at least twice a week. Ice Machine Cleaner.
Need help?
Do you have a question about the DXN 200 and is the answer not in the manual?
Questions and answers