Page 4
Removal • Pull Cube Deflector Out From Under Evaporators...
Page 5
Removal Cascading Shield • Locate Cascading Shield • Push Bottom of Shield Back to Release From Tabs on Eye Cascading Shield Push Bottom Holders Edge Back...
Page 6
Remove Cascading Shield • Lift the shield off the eye- holder tabs. Then pull Cascading Shield forward and down, out from under evaporators.
Page 7
Un-Bundle Wires • Photo-eye wires may be bundled together. Unbundle them to get slack so the eyes can be removed.
Page 8
Remove Eye-Holders • Pull the holders out of the left and right walls by pulling on the tabs.
Page 9
Clean the Photo-Eyes • Push in to release module from holder • Gently remove scale from Lenses lenses, use soft cloth and diluted scale remover. Note: Prior design did not have separate module.
Page 10
Reassembly • Snap module back into holder • Be sure wire is clipped as shown • Insert holders into wall of freezing compartment • Place cascading shield onto holder • Snap onto tabs...