Related Manuals for Thule 9025XT
Summarization of Contents
General Information
Manufacturer Liability Disclaimer
Thule disclaims liability for damages from improper mounting or use of the carrier.
No Carrier Modifications Allowed
The carrier and its parts must not be modified in any way.
Consult Dealer and Read Instructions
Consult your Thule dealer for questions and read all instructions before use.
Fitting Instructions
Check All Parts Before Fitting
Verify assembly instructions to ensure all necessary parts are present before fitting.
Follow Assembly Sequence Correctly
Read and follow assembly instructions and recommendations in the correct sequence.
Use Only Specified Fitting Method
Do not attempt to fit the carrier in any way other than shown in the mounting instructions.
Loading Guidelines and Capacity
Adhere to Maximum Load Limits
Do not exceed the maximum load for the carrier or the vehicle.
Ensure Secure Load Fastening
The load must be carefully secured; elastic bungees must not be used.
Observe Per-Bike Weight Limits
Check and do not exceed the maximum weight per bike specified in the instructions.
Optimal Bike Placement Strategy
Position largest and heaviest bikes closest to the car, followed by smaller ones.
Bike Frame and Carbon Compatibility
Carrier is for standard frames; check maximum frame size and carbon frame compatibility.
Remove Loose Bike Components
Remove easily removable bike parts like child seats, baskets, and pumps before transport.
Vehicle Hatchback Operation
Disable automatic tailgate opening; open manually to avoid damage.
Third Brake Light Visibility Requirements
Ensure carrier/load does not obstruct the vehicle's third brake light.
Retain Instructions with Vehicle
Keep mounting and safety instructions in the vehicle where the carrier is mounted.
Compatibility Restrictions (Tandems, Trailers)
Not intended for tandems or recumbents; do not install on trailers.
Driving Safety and Regulations
Off-Road Driving Prohibited
Product is not approved for off-road driving; adapt speed to road conditions.
Driver Responsibility for Safety
Driver is responsible for carrier condition and secure fastening of carrier and load.
Perform Regular Safety Checks
Check carrier security after short distance (50km) and at regular intervals.
Vehicle Dimension Changes
Be aware of increased vehicle length/height and exercise care when reversing or entering garages.
Replace Damaged or Worn Parts
Replace any damaged or worn parts of the carrier immediately.
Ensure Fasteners are Tightened
Ensure all levers, bolts, and nuts are tightened in accordance with mounting instructions.
Impact on Driving Characteristics
Be aware of changes in driving, braking, and susceptibility to side winds.
Tail Light Obstruction Guidance
If tail lights are obstructed, fit an external light board if the carrier lacks integrated lights.
Additional Number Plate Requirement
An additional number plate might be required, attached per local laws.
Adjust Speed to Conditions
Adjust speed to load, road type, traffic, and speed limits (max 130 km/h).
Speed Limit on Speed Bumps
Drive slowly over speed bumps, with a maximum speed of 10 km/h.
Wind Noise Awareness
Be aware that wind noise may be generated during transport.
Remove Carrier When Not In Use
Remove the carrier from the vehicle when not in use for fuel economy and safety.
Maintenance Procedures
Perform Regular Cleaning
Clean the carrier regularly with warm water or car shampoo, especially after use in coastal or salted areas.
Lubricate Moving Parts
Lubricate the coupling mechanism and other moving parts when required.
Avoid Automatic Car Washes
Remove the carrier before using an automatic car wash.
Proper Storage After Removal
Store the carrier and its components in a dry, secure area when removed from the vehicle.
Use Genuine Thule Spare Parts
Use only genuine Thule spare parts for replacements to ensure quality and fit.
Streamline Spare Parts Ordering
Provide relevant product details and serial number for quick spare part orders.
Record Key and Lock Numbers
Note down the lock and key number found on your key for quick replacement.
Periodically Check Bolt Tightness
Periodically check the tightness of all bolts and knobs.
Inspect Rubber Straps for Wear
Check rubber straps for wear and replace them if worn.
Need help?
Do you have a question about the 9025XT and is the answer not in the manual?
Questions and answers