Desa RH10PT Owner's Operation And Installation Manual page 6

INSTALLATION
Continued
CAUTION: This heater cre-
ates warm air currents. These
currents move heat to wall sur-
faces next to heater. Installing
heater next to vinyl or cloth wall
coverings or operating heater
where impurities (such as, but
not limited to, tobacco smoke,
aromatic candles, cleaning flu-
ids, oil or kerosene lamps, etc.) in
the air exist, may discolor walls
or cause odors.
CAUTION: If you install the
heater in a home garage
• heater pilot and burner must
be at least 18" above floor.
• locate heater where moving
vehicle will not hit it.
For convenience and efficiency, install heater
• where there is easy access for operation, inspec-
tion and service
• in coldest part of room
6"
Minimum
From
Sides Of
Heater
Left
Side
FLOOR
Figure 2 - Mounting Clearances As
Viewed From Front of Heater
6
CEILING
36"
Minimum
Right
Side
Minimum To
Top Surface
Of Carpeting,
3" Minimum To Top Surface
Tile Or Other
Of Carpeting, Tile Or Other
Combustible
Combustible Material
Material
www.desatech.com
THERMOSTAT SENSING BULB
The thermostat sensing bulb is located inside the
heater. Do not move this bulb during installation
or operation of the heater.
INSTALLING HEATER TO WALL
Marking Screw Locations
1. Determine where you will locate heater.
WARNING: Maintain mini-
mum clearances shown in Figure
3. If you can, provide greater
clearances from floor and join-
ing wall.
2. Mark two mounting screw locations on wall
(see Figure 3).
Installing Two Mounting Screws
Note: Wall anchors and mounting screws are
in hardware package. The hardware package is
provided with heater.
8 / "
7
8
Minimum To
Maintain 6"
Clearance
From Wall
FLOOR
Figure 3 - Mounting Screw Locations
Attaching To Wall Stud Method
For attaching mounting screw to wall stud
1. Drill hole at marked location using 9/64" drill
bit.
2. Insert mounting screw into wall stud.
3. Tighten screw until 1/16" space (thickness of
penny) is between screwhead and wall.
Attaching To Wall Anchor Method
Follow instructions below to attach mounting
screws to hollow walls (wall areas between studs)
or solid walls (concrete or masonry).
1. Drill holes at marked locations using 5/16"
drill bit. For solid walls (concrete or masonry),
drill at least 1 /
1
4
2. Fold wall anchor (see Figure 4, page 7).
7 / "
3
4
20
Mounting
Minimum To
Screw
Maintain 3"
Locations
Clearance
From Floor
" deep.
110373-01E
/ "
1
4