Advertisement
DISMANTLING
AND ASSEMBLING
INSTRUCTIONS
Disassembling
Assembling
1. Drive out rear wheel hub with special
tool P 297 a.
1. Heat trailing arm. Insert outer bearing
races and drive in with an appropriate
mandrel.
2. Install parking brake with anchor and
guard on trailing arm. Install inner
cross spring.
2. Pull wheel bearings off of rear wheel hub.
Use extracter with grip ring. Only grab hold
of bearing at rollers.
3. Lubricate bearing surfaces of trailing arm
with a multi-purpose lubricant (fill space
between both bearing surfaces in arm).
4. Place outer bearing in arm. Lubricate
taper rollers.
3. Heat trailing arm (heating plate, oven).
Drive outer bearing races out of trailing
arm.
5. Press in outer shaft seal to correct
position.
6. Press wheel hub into outer wheel bearing.
Printed in Germany
Disassembling and Assembling Rear Axle
42-9
Advertisement
