GE AJCQ10ACC Owner's Manual And Installation Instructions page 9

Fan Switch
"['o reach the tim switch(es) l(mov( the
hont grille.
OnHeagCool a nd HeatPumpmodels,tile tim switch
level_ are locaL((1 in holes acc(ss(d through the
control box. The top switch is fbr COOLsetting_
and the bottom switch is tot HEATsetting_.
I sea small screwdriver to change the setting.
The unit is shipped i_-om tile fhcto_T set in tile
CONrsetting fbr COOLand in the CYCLEseuing
for HEAT
Cooloolymodelshave a zockez switch on the
hont ot the control box.
When set at CYCLE (down) the the cycles on and
offwhen cooling. When set at CONY(confimlous,
up) the the luns all the time, providing a more
b_dm_ced lempec, mne. The unit is shipl)ed in
lhe CONTs( tting.
ge.com
Temperature Limitiug
Limiting the maximum and minimum setting _,
l)r(.vcnts usel-_ fl-om tulning the control 1o the
exlreme heat or cool positions.
"File normal range of the lump control is
approximately (?')°Fto 85°E Tim control range
ma} b( narrowed by tile use of'the tempemun-(
limiting screws locat_ d behind the contrtd l)anel.
Limits (_ Limits
heat cool
temg temp
Each position equals approximately 3°E
Veut Control
The vent control is located behind tim front
grille on file right skte ot the air discharge area.
When set at CLOSE, only the air inside the room
will be circulamd and conditioned. When set at
OPEN, s ome inside air is exhausted outsid(.
rI() open or close the v('nt:
l. R(move ll_e front grille.
2. Remove the vent card screw.
3. Remove vent card, turn it over and rel)lnce
il by locating rear hole in card over locating
pin inside air discharge and rcauaching
screw at fi-ont.
The unit leavesthefactoH setat the CLOSE position.
Locating h ole
OPEN position
(Meshendtowardback)
Locating hole
CLOSE position
{Meshendtowald flont}
A# Direction
IIorizontal louvers
on the front grilk
l(t VO!/ (;Olltl'ol
the
air (lirection up
alld dowll.
P,em(y,e tile front
grille u_ ar!just tile
vcrtical louvcrs
side-t(_-side 1o
direct the air left
or right.
,9