GE AJCQ10ACC Owner's Manual And Installation Instructions page 18

Installation Instructions
WINDOW INSTALLATIONmOPTIONAL (cont.)
[] PREPAREWINDOW
[] Mark the centerline of the stool. Measure
from the centerline 13:W' on both sides for
the panel cuts.
Centerline
Sill
[] Measure 123A " from the centerline on both sides
for the sill support brackets.
Sill Centerline
Stool
Inside
Inside
Stool
[] INSTALL SILL SUPPORTS
[] Assemble the sill supports. Do not fully
tighten the spacer mounting screws at this
time.
Type B-_-------_ @
mypeE /i"
i
support
Lock nut -_-
Adjusting bolt -_,-
Large washer -_ _
(For use with wood
sills)
/ Spacer mounting
screws Type (A)
Space r
,)
[] Before attaching the sill supports, place
them on the window stool. Select the spacer
position that will place the spacer near the
outermost point on the sill. Tighten the
spacer mounting screws,
Screws are in position
SiLl
suppor[
"V" notch
[] Turn the bolts and tighten the lock nuts to make
the sill supports level or tilt down 1/8" to the
outside. Line up the "V" notch with 12%" marks.
Drill pilot holes and attach the sill supports.
Average sill
Narrow sill
Offset sill (such as brick or stone)
NOTES:
• On narrow sills, there may not be enough room to
use the lock nut.
• A deep offset sill may require a longer adjusting
bolt than the standard hex head bolt provided,
• On wood sills use the large washer between the
bolt head and the sill. This prevents the bolt from
digging into the wood.
18