Desa SBVBP Owner's Operation And Installation Manual page 7

CAST IRON STOVE AND B-VENT
BURNER SYSTEM ASSEMBLY
Continued
INSTALLING B-VENT BURNER SYSTEM INTO
STOVE BODY
1. Carefully lift burner system and place into stove body from
the rear of stove.
2. Place the left and right grate tops into the top of stove body. Dis-
card center grate top of stove and replace with center grate top
provided with burner system.
Center Top Grate
(Included with
Burner System)
Left Top
Grate
Cast Iron
Stove Body
Figure 15 - Installing Burner System Into Cast Iron Stove Body
INSTALLING OPTIONAL BLOWER
ACCESSORY
NOTICE: If installing blower in an existing stove
burner system with gas connections, shut off gas
supply and disconnect heater from gas supply. Con-
tact a qualified service person to do this.
1. Remove 4 hex screws securing rear cover to back of stove body
(see Figure 16).
2. Separate bottom cover from rear cover by loosening the 8
mounting screws (see Figure 16).
3. Align the holes in the top mounting tabs of blower with the
holes in wall of rear cover. Using the 4 screws provided, mount
blower and tighten screws securely (see Figure 17).
4.
Thermostat Blower Only:
inside rear cover wall with two hex head screws provided as shown
in Figure 17. After securing bracket to rear cover, carefully bend
along existing bend line on bracket to almost a 90° angle (see
Figure 17). This will allow thermal switch to be positioned against
stove rear wall and sense temperature when in operating mode.
For more information, visit www.desatech.com
For more information, visit www.desatech.com
112127-01B
CAST IRON STOVE AND B-VENT BURNER SYSTEM ASSEMBLY
Right Top Grate
Burner
System
Attach thermal switch and bracket to
Installing B-Vent Burner System Into Stove Body
Installing Optional Blower Accessory
Hex Screws
Stove Body
Bottom Cover
Figure 16 - Removing Rear Cover and Bottom Cover from Stove
Body
Blower
Control
Locknut
Knob
Control Shaft
Thermal Switch
and Bracket
Mounting Holes
Blower
Assembly
Figure 17 - Blower Assembly, Speed Control, and Thermal
Switch Locations
Rear Cover
Mounting
Screws
Mounting
Screws
Speed
Control
TOP VIEW
Mounting Holes
7 7
Screws