Cast Iron Stove And B-Vent Burner System Assembly - Desa SBVBP Owner's Operation And Installation Manual

PRE-INSTALLATION
PREPARATION
Continued
4"
Figure 4 - Clearance for Corner Installation
1
19 / "
2
Figure 5 - Stove With Burner System Bottom Dimensions
CAST IRON STOVE AND B-VENT
BURNER SYSTEM ASSEMBLY
STOVE BODY ASSEMBLY
1. Lift off corrugated box enclosing stove body crating.
2. Remove all screws fastening the wood frame enclosure. Spread wood
frame open and lift away from plastic-bagged stove body. The bot-
tom pieces of pallet wood will remain bolted to the stove body.
3. Remove plastic bag from stove body.
4. Locate the product identification label on the carton and record the
model number and 7 digit serial number in the space provided in
the back of this owner's manual. Retain this operation and installa-
tion manual for future reference and warranty.
5. Remove back panel from stove and discard (see
Amity Only:
Figure 6). Use an adjustable wrench or a 10 mm socket. Re-
move six (6) bolts and washers. Keep bolts and washers to
reattach rear cover.
6. Remove all contents from inside stove cavity. Contents include:
(1) - Stove bottom [Amity Only] (Discard - Not used with
this application)
(4) - Legs with leg leveler bolts
(1) - Bottom door
(3) - Top grates
(1) - Hardware kit bag with fasteners
For more information, visit www.desatech.com
For more information, visit www.desatech.com
112127-01B

CAST IRON STOVE AND B-VENT BURNER SYSTEM ASSEMBLY

4"
26 1 / "
4
Front
PRE-INSTALLATION PREPARATION
Location and Space Requirements (Cont.)
7. Carefully lay stove body on back to attach bottom components to
stove body (see Figure 7). Rest stove on drop cloth or blanket to
avoid scratching stove edges.
8. Remove remaining pallet wood attached to bottom of stove
body (see Figure 8). Use an adjustable wrench to remove bolts.
9. Fasten each leg to stove with four (4) M8 x 1.25 - 20mm bolts.
Use a flat washer and lock washer with each bolt. Tighten bolts
into threaded holes on stove body (see Figure 9 and Figure 10
on page 6). Use an adjustable wrench or a 12mm socket.
Bolt
Back Stove
Panel
Figure 6 - Removing Back Panel (Amity™ Only)
Top of Stove Unit
Front of
Stove
Unit
Drop
Cloth/
Blanket
Figure 7 - Laying Down Stove On Side
Bolt
Pallet Wood
Figure 8 - Removing Pallet Wood From The Bottom of The Stove
Door Hinge
Step Bolt Hole
Bottom Of
Stove Unit
Figure 9 - Locating Threaded Holes for Legs and Door Attachment
Stove Body Assembly
Front of
Stove Unit
Pallet
Wood
Bolted to
Bottom of
Stove
Body
Front
Pallet
Wood
Bottom Of
Stove Unit
Front
Door Catch Bolt
With Adjustable
Hex Nuts Hole
Leg Hole
5 5
Top of
Stove
Unit