Desa SBVBP Owner's Operation And Installation Manual page 6

CAST IRON STOVE AND B-VENT BURNER SYSTEM ASSEMBLY
6
Stove Body Assembly (Cont.)
CAST IRON STOVE AND B-VENT
BURNER SYSTEM ASSEMBLY
Continued
10. Attach stove door by inserting step bolt through door hinge
pivot hole and into threaded hole in stove body (see Figure 11
and Figure 9 on page 5). Use an adjustable wrench or a 12mm
socket to fasten step bolt. Tighten step bolt until snug. Make
sure door moves freely.
11. Install door catch bolt (M8 x 1.25-55mm with two M8 hex
nuts) into threaded hole on stove body (see Figure 9, page 5).
Use an adjustable wrench or a 12mm socket. The catch bolt
has two hex nuts attached to it (see Figure 12). The top nut is a
bolt stop and the bottom nut is for door leveling adjustment.
12. Check general catch bolt alignment with door claw. Make fi-
nal adjustment and door leveling after stove is in normal stand-
ing position.
13. Carefully lift stove back up on its four attached legs.
Removing Front Surround Panel
Remove 2 bolts from bottom of stove and set aside. Remove bolt
from the top of the stove to remove the front panel assembly (see
Figure 13).
Washers
Bolt
Figure 10 - Attaching Stove Legs (Oxford™ Model Shown)
Stove Door
Threaded
Hole
Door Hinge
Step
Bolt
Bolt Shoulder
Figure 11 - Attaching Stove Door
For more information, visit www.desatech.com
For more information, visit www.desatech.com
Bottom Of
Stove Unit
Leg
Door
Bolt Stop
Adjusting
Door Claw
Nut
Catch Bolt
Figure 12 - Catch Bolt and
Door Claw Orientation
Removing Screen (Optional)
Amity Models
1. Lay the front panel assembly face down on a protected sur-
face. Remove the two screws that hold the front plate onto the
front surround plate (see Figure 14). Save these screws.
2. Remove the screws and washers that hold the screen onto the
front surround plate. Discard these screws, washers, and screen
(see Figure 14).
3. Replace the two screws from step 1 to reassemble the front
plate and the front surround plate. Set this assembly aside un-
til burner system has been installed, logs have been placed
inside of burner system, and glass door to burner system insert
has been replaced.
Oxford or Victor Hearth Models
1. Lay the front panel assembly face down on a protected sur-
face. Remove the screws and washers that hold the screen onto
the front surround plate. Discard these screws, washers, and
screen (see Figure 14).
2. Set this assembly aside until burner system has been installed,
logs have been placed inside of burner system, and glass door
to burner system insert has been replaced.
Stove Body
Front
Assembly
Figure 13 - Removing Front Assembly (Oxford™ Model Shown)
Front
Screws
Surround
Plate
Screw with
Washer
Screen
Front Plate
Amity™ Model
Figure 14 - Removing Screen from Front Assembly
Bolt
Screw with
Washer
Screen
Front Surround
Plate and
Doors
Oxford™ or Victor Hearth™
Models
112127-01B