Table of Contents
Advertisement
CARBURETOR
P/N 0-80508S, 0-80508SA, 0-80783C, 0-80459SA (electric choke)
P/N 0-3310S, 0-3310C & 0-3310SA (manual choke)
INSTALLATION, TUNING, AND ADJUSTMENT
MANUAL
199R9934-3
NOTE: These instructions must be read and fully understood before beginning
installation. If this manual is not fully understood, installation should
not be attempted. Failure to follow these instructions, including the
pictures may result in subsequent system failure.
Advertisement
Table of Contents
Related Manuals for Holley 0-3310S
Summarization of Contents
Introduction and Removal Procedures
Introduction
Provides an overview of the Holley carburetor, contact information, and warranty guidelines.
Carburetor Removal Steps
Detailed instructions for safely removing the existing carburetor, including disconnecting lines and linkage.
Installation Notes by Vehicle Make
Chrysler Vehicle Applications
Specific installation warnings and requirements for Chrysler automatic overdrive transmissions.
Ford Vehicle Applications
Specific installation warnings and requirements for Ford automatic overdrive transmissions.
GM Vehicle Applications
Specific installation warnings and requirements for GM automatic overdrive transmissions.
General Installation and Setup
Carburetor Mounting and Linkage Check
Instructions for mounting the carburetor, checking throttle linkage for smooth operation.
Vacuum and Fuel Line Connections
Guidance on connecting various vacuum hoses, PCV, power brake line, and fuel lines.
Electric and Manual Choke System Setup
Procedures for connecting and adjusting electric and manual choke mechanisms.
Ford Automatic Transmission Linkage
Specific adjustment steps for the transmission kickdown linkage on Ford vehicles.
Air Cleaner Installation and Maintenance
Steps for installing the air cleaner, checking clearances, and general maintenance advice.
Carburetor Tuning and Adjustment
Choke Adjustment Procedures
Instructions for adjusting electric and manual choke settings for optimal cold start.
Idle Mixture Needle Adjustment
Procedure to adjust idle mixture screws using a vacuum gauge for optimal idle.
Float Level Check and Adjustment
Steps to check and adjust the primary fuel float level using the sight plug.
Specific Model Float Level Adjustment
Float level adjustment for specific models (0-80508SA, 0-80459SA, 0-3310SA) with clear sight glasses.
Secondary Float Level Adjustment
Guidance on setting the float level in the secondary fuel bowls.
Advanced Tuning and Specifications
Vacuum Operated Secondary Throttle Tuning
Explanation and procedure for tuning the vacuum secondary throttle operation.
Main Jetting Information
Tips and considerations for selecting and changing main jets based on altitude and application.
Power Valve Selection Guide
Guidance on choosing the correct power valve based on manifold vacuum and engine application.
Carburetor Specifications Table
A table detailing specifications like metering jets, discharge nozzles, and power valves for various models.
Need help?
Do you have a question about the 0-3310S and is the answer not in the manual?
Questions and answers