Table of Contents
Advertisement
INSTALLATION
10
Optional Mantel Installation (Cont.)
Installing Blower Assembly - GA4350T
INSTALLATION
Continued
7.
Carefully place fireplace on mantel base and center left to
right. Check for gas leaks. See Checking Gas Connections,
pages 14 and 15.
8.
Refer to instructions provided with the mantel for permanent at-
tachment to wall.
9. Slide mantel around fireplace. Be careful not to damage wall
or mantel.
10. Adjust assembly to remove any gaps. From back side of fire-
place, attach two 2" wood screws through base mounting blocks
attached to bottom sides of mantel into base (see instructions
provided with mantel).
11. Attach remaining two 3" wood screws from hardware pack
through openings inside of fireplace sides into the mantel. See
Figure 13 for screw hole location.
Screws
Figure 11 - Removing Screen
Hex Head
Screw
Figure 12 - Removing Hood Screws
Figure 13 - Removing Hood
For more information, visit www.desatech.com
For more information, visit www.desatech.com
Assembled Trim
Figure 14 - Attaching Trim to Fireplace
Screws
INSTALLING BLOWER ASSEMBLY - GA3450T
when servicing controls. Wiring errors can cause im-
proper and dangerous operation.
Note: If you are using a mantel with your heater, use the following
Hood
instructions. If your heater is built-in, see For Built-In Installation
on page 12.
1. Screen and hood should be removed from fireplace (see page
Screen Rod
Cover
2. Install snap bushings found in hardware kit into both holes in
3. Make sure the wire harness is firmly connected to the terminals
Mantel Screw
Location
Figure 15 - Installing Snap Bushings
CAUTION: Label all wires prior to disconnection
CAUTION: Verify proper operation after servicing.
10). Remove log set and set aside.
rear of blower control shield (see Figure 15).
on the blower bracket assembly.
Blower Control
Shield
Shoulder Screws
Snap Bushing
111410-01C
Advertisement
Table of Contents
