Related Manuals for Goldair GNT7
Summary of Contents for Goldair GNT7
- Page 1 Operating Instructions Curved Round Towel Warmers For Models: GLTR5C, GNT7, GLTR7C, GLTR9C...
- Page 3 If parts are missing or the Towel Rail has been damaged, contact the Goldair Customer Services Team. 24. If your Towel Rail does not work, or is not working properly, contact the place of purchase or the Goldair Customer Services Team. Repair work on the Towel Rail by unqualified persons can cause serious risk to the user.
- Page 4 Components 2 x Upper Legs 4 x Grub Screws (note the centre hole) (Already fitted to Legs) 2 x Lower Legs 2 x Short Screws (note the offset hole) for Securing Upper Legs 1 leg has a cut out for exposed wire install 4 x Mounting Bush 2 x Screws already installed...
-
Page 5: Specifications
Specifications DIMENSIONS Model: GLTR5C GLTR7C GNT7 GLTR9C Height: 570mm 800mm 800mm 1030mm Width: 630mm 630mm 460mm 630mm Depth: 140mm 140mm 135mm 140mm ELECTRICAL Wattage: 110W Colour: Silver Silver Silver Silver Power supply: 220-240 VAC 50Hz International Protection Rating: IP55... - Page 6 Dimensions GLTR5C GLTR7C...
- Page 7 Dimensions (continued) GNT7 GLTR9C...
- Page 8 WALL PREPARATION Goldair Heated Towel Rails may be fixed to any type of wall, timber stud, steel stud or masonry (solid or cavity). Stud walls (timber or steel) require studs at the correct position for all rails. If the precise position can’t be determined early in the job, consider sheets of 18mm construction ply, covering a larger area.
-
Page 9: Mounting Instructions
600mm above the floor. The Ladder Towel Rail should be installed in accordance to local governing ASNZS regulations. The Goldair Heated Towel Rail can only be mounted 1 way. Your towel rail is mounted by legs with a single screw on each of the 4 legs as indicated in the illustration below. - Page 10 Installing your Towel Warmer Feed a short Screw (#9) through the middle of the upper leg (#1). There is a locator hole at the base end which this screw should line up with and pass through. Align the short screw with the locator of the upper leg positions on the towel rail, ensure grub screw is facing down.
- Page 11 Installing your Towel Warmer Drill holes. If installing into Gib board, Concrete or Block, insert wall plugs (#12) into the wall. 10. If using an exposed cable, insert a long screw through the mounting bush, then fix into wall plug ensuring the fit is secure.
- Page 12 PROOF OF PURCHASE To receive warranty, retain receipt as proof of purchase. SUPPORT AND TECHNICAL ADVICE Goldair – New Zealand Goldair – Australia Monday – Friday 8am-5pm Monday – Friday 8am-5pm...
-
Page 13: Two Year Warranty
In non-domestic use Goldair limits the voluntary warranty to three months. Goldair undertake to repair or replace this product at no charge if found to be defective due to a manufacturing fault during the warranty period. - Page 14 New Zealand PO Box 100707, North Shore Mail Centre, Auckland, 0745 www.goldair.co.nz Australia PO Box 574, South Morang, Victoria, 3752 www.goldair.com.au...
Need help?
Do you have a question about the GNT7 and is the answer not in the manual?
Questions and answers