Related Manuals for Goldair select ETR3BSS
Summary of Contents for Goldair select ETR3BSS
- Page 1 Operating Instructions Compact 3 Bar Towel Warmers * Available in either stainless steel or white For Models: ETR3BSS & ETR3BW...
-
Page 3: Safety Information
Safety Information YOUR SAFETY IS IMPORTANT TO US. PLEASE ENSURE YOU TAKE NOTE OF THE INSTRUCTIONS AND WARNINGS OUTLINED IN THIS MANUAL. When using this electrical appliance, basic safety precautions should always be observed. This product is intended to warm and dry towels and is therefore hot to the touch. Note that your towel warmer is intended to operate at 40–50 degrees however the surface temperature of your towel rail will generally operate 20-25 degrees higher than the ambient air temperature. -
Page 4: Specifications & Dimensions
Specifications SPECIFICATIONS/DIMENSIONS Model: ETR3BSS / ETR3BW Height: 535mm Width: 540mm ELECTRICAL Wattage, Painted – White: Stainless Steel: Power supply: 240 VAC 50Hz International Protection Rating: IP55 Dimensions... -
Page 5: Installation
Components 3 x Leg Brackets 3 x Short Screws 3 x Mounting Bush 3 x Long Screws 3 x Wall Plugs 1 x Allen Key and 3 grub screws Installation Always choose a safe location for the Towel Rail, keeping in mind the safety precautions outlined. - Page 6 Plasterboard in particular will not hold long term. WALL PREPARATION • Goldair Heated Towel Rails may be fixed to any type of timber stud, steel stud or masonry (solid or cavity) wall. • Walls made from timber or steel require studs at the correct position for all rails. If the precise position can’t be determined early in the job, consider sheets of 18mm construction...
-
Page 7: Electrical Installation
Electrical Installation MOUNTING • Choose a suitable position on the wall to mount the Heated Towel Rail. The flex entry must be horizontal and at the bottom of the frame. • Fit the leg brackets shown in figure 1. • Place the Heated Towel Rail on a flat surface, check that all the leg brackets are sitting parallel, if not parallel, re-tightening may be required. - Page 8 PROOF OF PURCHASE To receive warranty, retain receipt as proof of purchase. SUPPORT AND TECHNICAL ADVICE Goldair – New Zealand Goldair – Australia Monday – Friday 8am-5pm Monday – Friday 8am-5pm...
-
Page 9: Two Year Warranty
In non-domestic use Goldair limits the voluntary warranty to three months. Goldair undertake to repair or replace this product at no charge if found to be defective due to a manufacturing fault during the warranty period. - Page 10 New Zealand PO Box 100707, North Shore Mail Centre, Auckland, 0745 www.goldair.co.nz Australia PO Box 574, South Morang, Victoria, 3752 www.goldair.com.au...
Need help?
Do you have a question about the select ETR3BSS and is the answer not in the manual?
Questions and answers