Advertisement
Quick Links
Advertisement
Related Manuals for Storm Shell 65
Summary of Contents for Storm Shell 65
- Page 1 STORM SHELL Installation Instructions for 55" & 65” Storm Shell Pole Mount...
- Page 2 Installation Instructions for 55” & 65” Storm Shell TV Hard Cover. The 55 or 65 Storm Shell Pole Mount allows the 55 or 65 Storm Shell hard cover, and TV bracket to be assembled to a vertical cylindrical pole.
- Page 3 Caution Prior to installation of this product, the installation instructions should be read and completely understood. The installation instructions must be read to prevent personal injury and property damage. Keep these installation instructions in an easily accessible location for future reference.
-
Page 4: Tools Required
Tools Required Phillips head screw driver or electric drill 13mm Socket and Wrench Bubble Level Electric drill, ¼” drill bit for mounting holes 55/65 Storm Shell Pole Mount Hardware: ITEM NAME QUANTITY PICTURE 1.5” U-Bolt 2.0” U-Bolt 3.0”... - Page 5 Position the Pole Mount Plate on the back of the Storm Shell. Make sure the flat side of Mount Plate is lying flat against Storm Shell Hard Cover Back (Figure 4a and 4b). Line up pre-drilled TV Mounting holes on Storm Shell Hard Cover with holes on Pole Mount Plate.
- Page 6 4b). Use Bubble Level to ensure the Pole Mount Bracket is level. If (4) bolts were assembled prior to marking drill locations, dis-assemble (4) M8 bolts. Next, remove Pole Mount Bracket and use ¼” drill bit in Electric Drill to drill through body of Storm Shell TV Hard Cover Body (Figure 4c).
- Page 7 Figure5b Figure 5c (assembled) 4. Position back part of the Storm Shell TV Hard Cover on the assembled vertical Pole Mount Plate. Assemble (4) M6 x 16mm bolts (L5) through the back side of the Pole Mount Plate through corresponding drilled holes on the Storm Shell TV Hard Cover Body from Step 2. The Hole Locations...
- Page 8 Figure 6a Figure 6b 5. Connect Storm Shell TV Mounting Bracket to the Pole Mount Plate through the TV Hard Cover Body (Figure 7a). Fasten using (4) M8 x 30mm bolts (L6) starting from the back of the Pole Mounting Plate through the corresponding holes on the TV Hard Cover, and through the holes (4) on TV Mounting Bracket vertical plate.
- Page 9 Figure 7a Figure 7b...
- Page 10 PLEASE NOTE: The following parts included in the Storm Shell TV Mounting Hardware are included with the Storm Shell TV Hard Cover. When Installing the Storm Shell Pole Mount, some of the mounting components included with the Storm Shell TV Hard Cover are not used. These are the components normally used to mount the TV bracket onto a wall.
- Page 11 2. Storm Shell Front (right part) 1 pc 3. Storm Shell Back (left part) 1 pc 4. Storm Shell Back (right part) 1 pc TV bracket (preassembled in Storm Shell Back right part) 1 set Connecting Parts 1. Top Connecting Bar 1pc 2.
- Page 12 4. Middle Connecting Plate 1 pc 5. Buckle Latch 4 sets Screws Name Picture Name Picture M8X15 Screw ST8.0X60 Lag Bolt NOT USED POLE MOUNT ASSEMBLY M4X8 Screw 3-hole Washer M4X14 Screw Thick Washer M5X25 Screw D8 Washer M6X25 Screw D6 Washer M8X25 Screw M8 nut...
Need help?
Do you have a question about the 65 and is the answer not in the manual?
Questions and answers