Related Manuals for Haas TL-4
Summarization of Contents
Safety Guidelines
Workholding Safety
Safety practices for workholding equipment and machine operation.
Machine Installation
Shipping Bracket Removal
Instructions for removing shipping brackets for TL-1/2/3 and TL-4 models.
Lathe Leveling
Procedure to level the machine using a machinist's level and the X-axis.
TL-4 Lathe Leveling
Detailed steps for leveling the TL-4 model using an electronic level.
Electricity Requirements
Power source requirements, voltage, frequency, and harmonic distortion.
Connecting the Toolroom Lathe to Power
Step-by-step guide for connecting the lathe to the power supply.
Machine Operation
Power Up Procedure
Steps to power on the lathe and initiate the homing sequence.
Optional Tailstock Operation (TL-4)
Instructions for operating the optional tailstock for TL-4 models.
Tool Turret Service
Procedures for removing, reinstalling, and aligning tool turrets.
Manual Operation Modes
Overview of manual control modes including axes, spindle, and position.
Tool Offset Configuration
Details about tool offset parameters like Tool Number, X/Z Offset, Wear, Radius, Taper, Tip.
Automatic Machining Mode
How to set tool offsets for automatic operations and start machining.
IPS Recorder Functionality
Using the IPS recorder to place G-code into programs.
Alarm and Message Display
Alarm System Overview
How to access and view current and historical alarms.
Message Display System
Operator message display functionality.
Machine Maintenance
Lathe Lubrication Procedures
Procedures for lubricating linear guides, ball screws, and other components.
Chip Filter Maintenance
How to check and clean the chip filter.
Need help?
Do you have a question about the TL-4 and is the answer not in the manual?
Questions and answers