Product Identification; Local Codes - Desa (V) CD36R(N Owner's Operation And Installation Manual

SAFETY INFORMATION
Continued
5. This fireplace reaches high temperatures, Keep children and
adults away from hot surfaces to avoid burns or clothing igni-
tion. Fireplace will remain hot for a time after shutdown. Al-
low surfaces to cool before touching.
6. Carefully supervise young children when they are in the room
with fireplace.
7. Do not modify this fireplace under any circumstances. Any
parts removed for servicing must be replaced prior to operat-
ing fireplace.
8. Turn fireplace off and let cool before servicing, installing, or
repairing. Only a qualified service person should install, ser-
vice or repair this fireplace. Have fireplace inspected annu-
ally by a qualified service person.
9. You must keep control compartments, burners, and circulat-
ing air passages clean. More frequent cleaning may be needed
due to excessive lint and dust from carpeting, bedding mate-
rial, etc. Turn off the gas valve and pilot light before cleaning
fireplace.
10. Have venting system inspected annually by a qualified service
person. If needed, have venting system cleaned or repaired.
See Cleaning and Maintenance, page##.
11. Keep the area around your fireplace clear of combustible ma-
terials, gasoline, and other flammable vapor and liquids. Do
not run fireplace where these are used or stored. Do not place
items such as clothing or decorations on or around fireplace.
12. Do not use this fireplace to cook food or burn paper or other
objects.
13. Do not use any solid fuels (wood, coal, paper, cardboard, etc.)
in this fireplace. Use only the gas type indicated on the
nameplate.
14. This appliance, when installed, must be electrically grounded
in accordance with local codes or, in the absence of local codes,
with the National Electric Code, ANSI/NFPA 70, or the Ca-
nadian Electric Code, CSA C22.1.
15. Do not use fireplace if any part has been exposed to or under
water. Immediately call a qualified service person to arrange
for replacement of the unit.
16. Do not operate fireplace if any log is broken or missing.
17. Do not use a blower insert, heat exchanger insert, or other ac-
cessory not approved for use with this fireplace.
18. Do not operate fireplace with glass door removed, cracked, or
broken.
19. Provide adequate clearances around air openings.
NOTICE: This product is intended only as a supple-
ment to your central heating system and is not to be
installed as a primary source of heat. You may use this
product for emergency heating during a power outage.
116035-01B

PRODUCT IDENTIFICATION

Upper
Louver
Panel
Glass
Door
Assembly
Lower
Louver
Panel
Junction Box
Figure 1 - Rear / Top Direct-Vent Fireplace

LOCAL CODES

Install and use fireplace with care. Follow all local codes. In the
absence of local codes, use the current National Fuel Gas Code
ANSI Z223.1/NFPA 54* (USA) or the current CSA-B149.1 Instal-
lation Code (Canada).
*Available from:
American National Standards Institute, Inc.
National Fire Protection Association, Inc.
www.desatech.com
SAFETY INFORMATION
PRODUCT IDENTIFICATION
LOCAL CODES
Control Valve Piezo Ignitor with
Variable Input Optional Remote and
Blower Control Mount
Adjustment
1430 Broadway
New York, NY 10018
Batterymarh Park
Quincy, MA 02269
3
Rear Vent
Flue Collar
Top Vent
Flue Collar
Door Latch
Log
Set
Ember
Tray
Nailing
Flange