Boot Settings Screen; Integrated Devices Screen - Dell PowerVault NX400 Owner's Manual

Menu Item Description
Port C Auto enables BIOS support for the device attached to SATA port C. By default, Port C is set to
Auto.
Port D Auto enables BIOS support for the device attached to SATA port D. By default, Port D is set to
Auto.
Port E Auto enables BIOS support for the device attached to SATA port E. By default, Port E is set to
Auto.
NOTE: Ports A, B, C, and D are used for the backplane drives, and port E for the optical drive (CD/DVD).

Boot Settings Screen

Menu Item Description
Boot Mode Allows you to set the boot mode of the system.
If the operating system supports UEFI, you can set this option to UEFI. Setting this field to BIOS
allows compatibility with non-UEFI operating systems. By default, the Boot Mode option is set
to BIOS.
Boot Sequence Retry Allows you to enable or disable the boot sequence retry feature. If this field is enabled and the
system fails to boot, the system reattempts the boot sequence after 30 seconds. By default, the
Boot Sequence Retry option is set to Disabled.
BIOS Boot Settings Allows you to enable or disable BIOS Boot options.
UEFI Boot Settings Allows you to enable or disable UEFI Boot options.
One-Time Boot Allows you to enable or disable a one-time boot from a selected device.

Integrated Devices Screen

Menu Item Description
Integrated RAID Allows you to enable or disable the integrated RAID controller. By default, the Integrated RAID
Controller Controller option is set to Enabled.
22
CAUTION: Switching the boot mode may prevent the system from booting if the operating
system is not installed in the same boot mode.
NOTE: Setting this field to UEFI disables BIOS Boot Settings menu. Setting this field to
BIOS disables the UEFI Boot Settings menu.
NOTE: This option is enabled only if the boot mode is BIOS.
NOTE: This option is enabled only if the boot mode is UEFI.
NOTE: This option is displayed only if integrated RAID controller is installed on the system.