HP 4400 Release Note page 28

Fabric OS version
Fabric OS 6.1.2x and
6.2.0d through 6.2.x
Updated command message:
When executing the lscfg --create command with the following syntax:
switch_128:FID128:admin> lscfg --create 1 About to create switch
with fid=1. Please wait... Logical Switch with FID (1) has been
successfully created.
You should expect to see the following revised message:
Logical Switch has been created with default configurations. Please
configure the Logical Switch with appropriate switch and protocol
settings before activating the Logical Switch.
Web Tools functionality moved to DCFM
The functionality that was moved from Web Tools 6.1.1 to DCFM applies to all versions of DCFM
and also applies to Fabric OS 6.2.x.
Table 7 Web Tools functionality in DCFM
Function
Add unzoned devices
Analyze zone configuration
Define device alias
28
All 8-Gb switches except 8-Gb SAN
Switch for HP BladeSystem c-Class
Regardless of the Fabric OS version that
was previously installed, all ports default
to IDLE [mode 0]. However if they were
changed to ARB(FF) [mode 1] manually,
they remain in ARB(FF) mode.
Can be changed by the user.
Mode: 0 — IDLE for Link Init, IDLE for fill word
1 — ARB(FF) for Link Init, ARB(FF) for fill word (NOTE: not supported with XP storage
arrays)
Table 7 (page 28)
Web Tools 6.1.0
Zone Admin
Zone Admin
Zone Admin
8-Gb SAN Switch for HP BladeSystem
– If Fabric OS 6.2.0d was
factory-installed, all internal ports
remain at ARB(FF) [mode 1], and
external ports remain in IDLE [mode
0].
– If Fabric OS earlier than 6.2.0d was
factory-installed, all internal and
external ports remain at IDLE [mode
0]. However, if they were changed to
ARB(FF) [mode 1] manually, then they
remain in ARB(FF) mode.
Can be changed by the user.
describes these changes.
DCFM
Configure > Zoning
Reverse Find in the zoning dialog provides the view of
the zoned and unzoned devices in the fabric if all zone
members are selected for Find.
Configure > Zoning
Reverse Find in the zoning dialog provides the view of
the zoned and unzoned devices in the fabric if all zone
members are selected for Find.
Device Tree and Topology
Connected End Devices
Custom display from the top level in the main frame
provides the device tree and topology view for all the
zoned devices if all zones are selected in the active zone
configuration.
Configure > Zoning
c-Class