Brocade Communications Systems 1606 Manual page 19

10. Complete the following steps on the Server Configuration screen.
NOTE
Do not use port 2638 for any of these port numbers. Port 2638 is used internally by the server.
FIGURE 4 Server Configuration screen
a. Enter a port number in the Syslog Port # field (default is 514).
NOTE
If the default syslog port number is already in use, you will not receive any syslog messages from the device.
To find and stop the process currently running on the default Syslog port number, refer to
troubleshooting"
b. Select the SSL Enabled check box to enable SSL.
c. Enter a port number in the Web Server Port # field (default is 443 if SSL Enabled is selected; otherwise, the
default is 80).
d. Enter a port number in the SNMP Port # field (default is 162).
e. Enter a port number in the Starting Port # field (default is 24600).
NOTE
The server requires 16 consecutive free ports beginning with the starting port number.
f. Click Next.
If you enter a Syslog port number already in use, a message displays. Click OK to close the message. Edit
the Syslog port number and click Next.
If you enter a port number already in use, a Warning displays beneath the associated port number field. Edit
that port number and click Next.
DCFM Migration Guide
53-1001776-01
on page 36.
Professional edition migration
"Syslog
19 of 38