Removing Members From An Alias; Deleting An Alias - Brocade Communications Systems 1606 Administrator's Manual

11
Zone aliases
3. Enter the cfgSave command to save the change to the defined configuration.
Example

Removing members from an alias

1. Connect to the switch and log in as admin.
2. Enter the aliRemove command, using the following syntax:
3. Enter the cfgSave command to save the change to the defined configuration.
Example

Deleting an alias

1. Connect to the switch and log in as admin.
2. Enter the aliDelete command, using the following syntax.
3. Enter the cfgSave command to save the change to the defined configuration.
232
The cfgSave command ends and commits the current zoning transaction buffer to both volatile
and nonvolatile memory. If a transaction is open on a different switch in the fabric when this
command is run, the transaction on the other switch is automatically aborted. A message
displays on the other switches to indicate that the transaction was aborted.
switch:admin> aliadd "array1", "1,2"
switch:admin> aliadd "array2", "21:00:00:20:37:0c:72:51"
switch:admin> aliadd "loop1", "5,6"
switch:admin> cfgsave
You are about to save the Defined zoning configuration. This
action will only save the changes on the Defined configuration.
Any changes made on the Effective configuration will not
take effect until it is re-enabled.
Do you want to save Defined zoning configuration only? (yes, y, no, n): [no] y
aliremove "aliasname", "member[; member...]"
The cfgSave command ends and commits the current zoning transaction buffer to both volatile
and nonvolatile memory. If a transaction is open on a different switch in the fabric when this
command is run, the transaction on the other switch is automatically aborted. A message
displays on the other switches to indicate that the transaction was aborted.
switch:admin> aliremove "array1", "1,2"
switch:admin> aliremove "array2", "21:00:00:20:37:0c:72:51"
switch:admin> aliremove "loop1", "4,6"
switch:admin> cfgsave
You are about to save the Defined zoning configuration. This
action will only save the changes on the Defined configuration.
Any changes made on the Effective configuration will not
take effect until it is re-enabled.
Do you want to save Defined zoning configuration only? (yes, y, no, n): [no] y
alidelete "aliasname"
Fabric OS Administrator's Guide
53-1001336-01