Compaq 226593-B21 - Smart Array 5i RAID Controller User Manual page 109

Table F-1: POST Error Messages
Message
1724
1726
1727
1728
Compaq Smart Array 5i Plus Controller and Battery Backed Write Cache Enabler User Guide
Description
Slot x drive array –
physical drive position
change(s) detected –
logical drive
configuration has
automatically been
updated.
Slot x drive array –
array accelerator
memory size change
detected – array
accelerator
configuration has
automatically been
updated
Slot x drive array –
new logical drive(s)
attachment detected (if
>32 logical drives, this
message will be
followed by Auto-
configuration failed:
too many logical
drives)
Slot x drive array –
abnormal shutdown
detected with write
cache enabled.
No array accelerator
battery backup on this
model array controller.
Any data that may
have been in array
accelerator memory
has been lost.
continued
Meaning and Recommended Action
Logical drive configuration has been updated
automatically following physical drive position
changes. Press the F1 key to resume.
This message is displayed if the controller is
replaced with a model that has a different amount
of cache memory.
The controller has detected an additional array of
drives that was attached when the system was
powered down. The logical drive configuration
information has been updated to add the new
logical drives. The maximum number of logical
drives supported is 32—additional drives will not
be added to the configuration if this number is
exceeded. Press the F1 key to resume.
This message should never occur unless the write
cache is somehow enabled on a controller that
does not have batteries.
POST Error Messages
continued
F-3