Preparations And Connections; Installing Batteries In The Remote Control; Remote Control Operation Range - Yamaha GX-500RDS Owner's Manual

Installing batteries in the remote control

2

Remote control operation range

3–DISC VCD CHANGER
MINI COMPONENT SYSTEM
E-4

Preparations and connections

1
3
DISC 1 DISC 2 DISC 3 DISC CHANGE OPEN / CLOSE
PRESET/ TUNING/ BAND A/B/C/D/E
VOLUME
DOWN UP
PUSH OPEN
MODE–PTY SEEK– START
SET MD
REC/PAUSE
TAPE
GX–700
MD
MINIDISC RECORDER
0,2 m – 6 m
1.
Turn the remote control over and remove the battery
compartment cover by pulling it up while pressing the edge
of the cover in the direction of the
2.
Insert the batteries (AA, R6, UM-3 type) according to the
polarity markings on the inside of the battery compartment.
3
.
Attach the battery compartment cover.
Notes
● Remove the batteries if the remote control is not used for an
extended period of time.
● If batteries leak, dispose of them immediately. Avoid
touching the leaked material and contact with clothing, etc.
Clean the battery compartment thoroughly before installing
new batteries.
● Be sure to use the same type of batteries together.
● Do not use a new battery and an old battery together.
Notes
● The area between the remote control and the main unit must
be clear of large obstacles.
● Do not expose the remote control sensor to strong lighting,
in particular, an inverter type fluorescent lamp. Otherwise,
the remote control may not work properly. If necessary,
position the main unit away from direct lighting.
Battery replacement
If you find that the remote control must be used closer to the
main unit, the batteries are weak. Replace both batteries with
new ones.
mark.