MACROMEDIA FLASH MX 2004-USING ACTIONSCRIPT IN FLASH Use Manual page 46

Make sure to declare a Timeline variable before trying to access it in a script. For example, if you
put the code
var x = 10;
access that variable.
Local variables
To declare local variables, use the
declared within a function block is defined within the scope of the function block and expires at
the end of the function block.
For example, the variables
used as a local variable; it exists only inside the function
var myArray:Array = [ ];
function initArray(arrayLength:Number) {
var i:Number;
for( i = 0; i < arrayLength; i++ ) {
myArray[i] = i + 1;
}
}
Local variables can also help prevent name conflicts, which can cause errors in your application.
For example, if you use
context and the age of a person's child in another; because these variables would run in separate
scopes, there would be no conflict.
It's good practice to use local variables in the body of a function so that the function can act as an
independent piece of code. A local variable is changeable only within its own block of code. If an
expression in a function uses a global variable, something outside the function can change its
value, which would change the function.
You can assign a data type to a local variable when you define it, which helps prevent you from
assigning the wrong type of data to an existing variable. For more information, see
typing" on page
Global variables
Global variables and functions are visible to every Timeline and scope in your document. To
create a variable with global scope, use the
use the syntax. For example, the following code creates the global variable
var =
var _global.myName = "George"; // incorrect syntax for global variable
_global.myName = "George"; // correct syntax for global variable
However, if you initialize a local variable with the same name as a global variable, you don't have
access to the global variable while you are in the scope of the local variable, as shown in the
following example:
_global.counter = 100; // declares global variable
trace(counter); // accesses the global variable and displays 100
function count(){
for( var counter = 0; counter <= 2 ; counter++ ) { //local variable
trace(counter); // accesses local variable and displays 0 through 2
46 Chapter 2: ActionScript Basics
in Frame 20, a script attached to any frame before Frame 20 cannot
statement inside the body of a function. A local variable
var
and are often used as loop counters. In the following example,
i j
as a local variable, you could use it to store a person's age in one
age
41.
initArray()
identifier before the variable name and do not
_global
:
"Strict data
:
myName
is
i