Desa EFS26PR Owner's Operation And Installation Manual page 21

Optional Wireless Hand-Held Remote Control Accessories [Remote-Ready Models Only] (Cont.)
INSTALLATION
Continued
Black Wire
Wire Harness*
Wires from
Valve
Black Wire
Figure 38 - Installing Remote Receiver
* Wire harness provided in the fireplace hardware pack.
Installing 9-Volt Battery in Hand-Held Remote
Control Unit
1. Remove battery cover on back of remote control unit.
2. Attach terminal wires to the battery (not included). Place bat-
tery into the battery housing.
3. Replace battery cover onto remote control unit.
Terminal
Wires
9-Volt
Battery
Figure 39 - Installing Battery in Hand-Held Remote Control Unit
(GHRC Series)
Terminal Wires
9-Volt
Battery
Battery
Housing
Figure 40 - Installing Battery in Hand-Held Remote Control Unit
(GHRCTA Series)
For more information, visit www.desatech.com
For more information, visit www.desatech.com
107032-01F
Optional Wall Mounted Thermostat - GWMT1 [Remote-Ready Models Only]
Remote
Receiver
Red Wire
Red Wire
Battery Cover
Remote
Control Unit
Battery
Housing
Remote
Control Unit
Battery Cover
OPTIONAL WALL MOUNTED THERMOSTAT -
GWMT1
(Remote-Ready Models Only)
WARNING: Read and follow installation instruc-
tions. Installation should be done by a qualified
installer familiar with low-voltage wiring procedures.
WARNING: Do not connect this thermostat to any
electrical source! Electrical shock and/or fire hazard
will occur.
1. Connect one terminal of 25 ft. wire to bottom contact of switch
(see Figure 41).
2. Connect remaining wire terminal to the "TH" terminal on the
control valve. Make sure that wire terminals are in the posi-
tions on your unit as pictured in Figure 41. If wires are not
"crossed" the thermostat will not work.
3. Route the 25 ft. wire to a convenient location to mount your
thermostat (no outside wall). IMPORTANT: The wire may be
shortened but must not be lengthened.
The thermostat should be mounted 54" above the floor in a loca-
tion where there is good air circulation. Avoid heat sources such
as lamps, direct sunlight, fireplace, or heat and air conditioning
ducts.
4. Gently remove the cover of the thermostat from the base. Grasp
the sides of the cover firmly and pull to separate from the base.
5. Feed the electrical wires through the rectangular slots on each
side of the base (see Figure 42, page 22).
WARNING: Do not connect the thermostat to a
power source. Electrical shock and/or a fire hazard
will occur.
Switch on Gas
Fireplace
Control
Valve
To Wall
One
Thermostat
terminal or Switch
of 25 ft.
wire
Figure 41 - Connecting Wire Terminals
INSTALLATION
21
21
To Wall
Thermostat
or Switch