Desa EFS10TN Owner's Operation And Installation Manual page 14

INSTALLATION
14
Installing Blower Accessory GA3450T in Remote-Ready Models (Cont.)
Installing Blower Accessory GA3450T in Thermostat-Controlled Models
INSTALLATION
Continued
3. A licensed electrician must follow the wiring diagram to con-
nect incoming electrical supply to fan kit wiring harness (see
Figure 19).
4. Plug power cord to the outlet receptacle (not provided) as shown
in Figure 20. Wind the extra cable in power cord and and tie it
up with the plastic wire strap (see Figure 20). Set the cable
bundle between the burner bracket and outer casing, away from
the burner.
5. Test to make sure the blower is working properly.
6. Reinstall upper louver assembly (see Figure 15, page 12) and
close lower louver.
110/115
V.A.C.
Figure 19 - Wiring Diagram For Blower Accessory Built-In
Installation
Blower Bracket
Assembly
Screw
Power
Switch
Cord
Switch
Blue
Plate
Black
Red
Plastic
Wire Strap
Wire Harness
Figure 20 - Installing Blower Bracket Assembly
For more information, visit www.desatech.com
For more information, visit www.desatech.com
Fan Switch
(Auto/Off/On)
Auto
1
2
Off
3
Thermostat
Blue
Switch
On
(N.O.)
Blue
Red
Black
Red
White
White
Green Green
Wire Harness
Outlet Receptacle
(Not Supplied)
Clamp Connector
(not included)
Lower Louver Door
Extension Cord
Use extension cord if needed. The cord must have a three-prong,
grounding plug and a three-hole receptacle. Make sure cord is in good
shape. It must be heavy enough to carry the current needed. An
undersized cord will cause a drop in line voltage. This will result in
loss of power and overheating. Use a No. 16 AWG cord for lengths
less than 50 feet.
INSTALLING OPTIONAL BLOWER
ACCESSORY GA3450T IN THERMOSTAT-
CONTROLLED MODELS
Removing Upper Louver Assembly
To install the blower accessory, you must first remove the upper
louver assembly.
1. Remove 4 screws from upper louver assembly (see Figure 21).
Save these screws.
Blower
Motor
2. Pull upper louver assembly straight out from the cabinet. Be care-
ful not to scratch the paint. Set louver assembly and screws aside.
Figure 21 - Removing Upper Louver Assembly
Blower Bracket
Mounting Holes
Brass
Screws
Upper Louver
Assembly
107032-01E