MACROMEDIA COLDFUSION MX 61 - CONFIGURING AND ADMINISTERING COLDFUSION MX Manual page 105

If an indexing task halts, you can rerun the task as-is. The persistent store for the specified
collection is read, and only those candidate URLs that are in the queue but not yet processed are
parsed. Candidate URLs correspond to URLs of the following status, as reported by vsdb:
cand, used, inse, upda, dele, fail
Repository type Starting point
Web The URL or URLs from which Verity Spider is to begin indexing. Use other
options, such as the
Verity Spider goes.
File The starting directory or directories in which Verity Spider will start indexing. All
subdirectories beneath the starting point will be indexed, unless you use the
-pathlen
Note: By using the
-start
Spider and therefore do not need to use at least one of the following options:
, or
-nofollow -unlimited
-refresh
Used for updating a collection, specifies that Verity Spider process only those documents that
qualify, as follows:
•
They are new documents in the repository, and they qualify for indexing under the criteria.
•
They exist in the collection and are recorded in the Verity Spider persistent store with a status
of done. If Verity Spider determines that these indexed documents have been updated in the
repository, then they are retrieved again to be reparsed and reindexed. The document
VdkVgwKey values do not change.
•
They are deleted in the collection. If Verity Spider determines that documents have been
deleted from the repository, then they are also deleted from the persistent store and the
collection. The exception to this rule is when you use the
option. In this case, any document deleted from the repository is marked for
-refresh
deletion in the collection. It will be removed from the collection and the persistent store when
the next indexing task is run for the collection.
When you rerun an existing indexing job, Verity Spider automatically refreshes the collection. If
you add or remove any of the starting points, however, you must manually specify the
option to refresh existing documents.
Note: You can also use the
use the option, use at least one of the following options:
-start
further control, also see the
Spider operates without limits and will likely index far more than you intended.
-jumps
option or any of the inclusion or exclusion criteria.
option with the
-refresh
.
option to provide a starting point for Verity Spider. If you do not
-start
option. If you do not use any constraint criteria, Verity
-refreshtime
option, to control how far from the starting point
option, you provide a starting point for Verity
-nooptimize
,
-host -domain
About Verity Spider syntax
, ,
-host -domain
option with the
-refresh
, or . For
-nofollow
105