Merging Collections Using The Merge Utility; Splitting Collections Using The Merge Utility - MACROMEDIA COLDFUSION MX 61 - CONFIGURING AND ADMINISTERING COLDFUSION MX Manual

Merging collections using the merge utility

The following is the syntax for using the merge utility to merge multiple collections into a single
collection:
merge <newCollection> <srcCollection1> <srcCollection2> [srcCollectionN]
The utility reads srcCollection1, srcCollection2 and so on and merges them into a single
collection with the directory name given for newCollection If the directory name given for
newCollection does not exist, it is created.

Splitting collections using the merge utility

The following is the syntax for using the merge utility to split a single large collection into smaller
collections:
merge -split <srcCollection> <newCollection1> <newCollection2> [-number]
The merge utility reads srcCollection and splits it into roughly equal pieces, using the filenames
given for newCollection1 and so on.
If you want to split a very large collection into a large number of new collections, you can use the
following command, instead of explicitly naming each new collection:
merge -split -number newCollection srcCollection
The merge utility reads the collection identified by srcCollection and splits it into the number of
segments specified by the
appending the first two letters in the alphabet (aa) to the directory name given for newCollection.
Each subsequent filename is generated by incrementing one of the appended letters (up to zz) for
a maximum of 676 partitions. For example, if the value of
newCollection is Collection1, the collections are named, Collection1aa, Collection1ab, and
Collection1ac.
Note: The maximum length of the directory name given for
the length allowed by the file system.
154 Chapter 12: Troubleshooting Collections with Verity Utilities
option. The name of the first new collection is generated by
-number
is 3, and the value of
-number
is two characters less than
newCollection