Desa Comfort Glow CF26PRA Owner's Operation And Installation Manual page 15

Desa owner's operation and installation manual unvented (vent-free) bay front gas log fireplace cf26pra , cf26nra
Table of Contents

Advertisement

INSTALLATION
Continued
WARNING: Never attempt to service heater while
it is plugged in, operating, or hot. Burns and elec-
trical shock could result. Only a qualified service
person should service or repair heater.
If any of the original wire as supplied with the appliance must
be replaced, original replacements must be used. DESA part
no. 104015-01 (105°C) for power cord, and DESA part no.
103968-01 (200°C) for wire harness.
WARNING: Label all wires prior to disconnection
when servicing controls. Wiring errors can cause
improper and dangerous operation. Verify proper
operation after servicing.
Fan Switch
(Auto/Off/On)
1
2
Off
110/115
V.A.C.
Black
Green
White
120 Vac. 60 Hz. .30 Amps
DESA Heating Products, Bowling Green, KY
Figure 18 - Wiring Diagram For Fan
Accessory Built-In Installation
CONNECTING TO GAS SUPPLY
WARNING: This appliance
requires a 1/2" NPT (National
Pipe Thread) inlet connection
to the pressure regulator.
WARNING: A qualified ser-
vice person must connect heater
to gas supply. Follow all local
codes.
CAUTION: Never connect pro-
pane/LP fireplace directly to the
propane/LP supply. This fireplace
requires an external regulator
(not supplied). Install the external
regulator between the fireplace
and propane/LP supply.
WARNING: Never connect
natural gas fireplace to private
(non-utility) gas wells. This
gas is commonly known as
wellhead gas.
113897-01A
Auto
Thermostat
Blue
Switch
3
(N.O.)
On
Blue
Blower
Motor
Red
Red
White
Green
101584-06
www.desatech.com
Installation Items Needed
Before installing fireplace, make sure you have
the items listed below.
• external regulator (supplied by installer)
• piping (check local codes)
• sealant (resistant to propane/LP gas)
• equipment shutoff valve *
• ground joint union
• sediment trap
• tee joint
• pipe wrench
• test gauge connection *
* A CSA design-certified equipment shutoff valve
with 1/8" NPT tap is an acceptable alternative to
test gauge connection. Purchase the optional CSA
design-certified equipment shutoff valve from your
dealer. See Accessories, page 35.
For propane/LP units, the installer must supply
an external regulator. The external regulator will
reduce incoming gas pressure. You must reduce
incoming gas pressure to between 11 and 14 inches
of water. If you do not reduce incoming gas pres-
sure, heater regulator damage could occur. Install
external regulator with the vent pointing down
as shown in Figure 19. Pointing the vent down
protects it from freezing rain or sleet.
CAUTION: Use only new,
black iron or steel pipe. In-
ternally-tinned copper tubing
may be used in certain areas.
Check your local codes. Use
pipe of 1/2" diameter or greater
to allow proper gas volume to
heater. If pipe is too small, undue
loss of volume will occur.
Propane/LP
Supply Tank
Figure 19 - External Regulator With Vent
Pointing Down
External
Regulator
Vent
Pointing
Down
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Comfort glow cf26nra

Table of Contents