INSTALLATION
Continued
For Built-In Installation
WARNING: A licensed elec-
trician must connect the wiring
harness to electrical supply
following all local codes. Electri-
cian must provide a clamp on the
box cover to secure the wiring.
Wiring should be routed through
the bushing in the hole on the
outer casing of heater.
WARNING: ELECTRICAL
GROUNDING INSTRUCTIONS
This appliance is equipped with a
three-prong (grounding) plug for
your protection against shock
hazard and should be plugged
directly into a properly grounded
three-prong receptacle.
Blower Bracket
Assembly
Screw
Switch
Switch
Plate
Blower
Control
Shield
14
Strain
Relief
Power
Cord
Blue
Clamp
Connector (not
included)
Figure 17 - Installing Blower Bracket Assembly
www.desatech.com
Wire
Harness
Outlet
Receptacle
Shield
Cover
Wire
Harness
113897-01A