Desa Comfort Glow CF26PRA Owner's Operation And Installation Manual page 11

INSTALLATION
Continued
Note: All vertical
measurements
are from top
of fireplace
opening to
bottom of
mantel shelf.
Minimum Non-
Combustible
Material
Figure 8 - Minimum Mantel Clearances
for Built-In Installation
REMOVING BRICK LINER
RETAINER
1. Using Phillips screw driver, remove 2 screws
attaching brick liner retainers to vertical
sides.
2. Remove brick liner retainers and discard.
Replace 2 screws into vertical sides.
ASSEMBLING TRIM
(Trim shipped with mantel)
1. Remove packaging from three pieces of
trim.
2. Locate two adjusting plates with set screws,
and two shims in the hardware packet.
3. Align shim under adjusting plate as shown in
Figure 9.
4. Slide one end of adjusting plate/shim in slot
on mitered edge of top trim (see Figure 9).
5. Slide other end of adjusting plate/shim in slot
on mitered edge of side trim (see Figure 9).
6. While firmly holding edges of trim together,
tighten both set screws on the adjusting plate
with slotted screwdriver.
7. Repeat steps 1 through 6 for other corner.
8. Set trim assembly aside for later installation.
113897-01A
Mantel Shelf
10"
8"
6"
2 1 / "
2
www.desatech.com
Slot
Set Screws
Shim
Adjusting
Plate
Slot
Figure 9 - Assembling Trim
Top
Trim
Mitered
Edge
Side
Trim
11