Russound A-BUS A-H484 Instruction Manual

Safety Instructions:
1. Read Instructions - All the safety and operating instructions should
be read before the appliance is operated.
2. Retain Instructions - The safety and operating instructions should
be retained for future reference.
3. Heed Warnings - All warnings on the appliance in the operating
instructions should be adhered to.
4. Follow Instructions - All operating and user instructions should be
followed.
5. Water and Moisture - The appliance should not be used near
water; for example, near a bathtub, washbowl, kitchen sink, laun-
dry tub, in a wet basement, or near a swimming pool.
6. Wall or Ceiling Mounting - The appliance should be mounted to a
wall or ceiling only as recommended by the manufacturer.
7. Ventilation - The appliance should be situated so that its location
or position does not interfere with its proper ventilation. For exam-
ple, the appliance should not be situated on a bed, sofa, rug, or
similar surface that may block the ventilation openings, or placed
in a built-in installation, such as a bookcase or cabinet that may
impede the flow of air through the ventilation openings.
8. Heat - The appliance should be situated away from heat sources
such as radiators, heat registers, stoves, or other appliances
(including amplifiers) that produce heat.
9. Power Sources - The appliance should be connected to a power
supply only of the type described in the operating instructions or
as marked on the appliance.
10.Grounding or Polarization - Precaution should be taken so that the
grounding or polarization means of an appliance is not defeated.
11.Power Cord Protection - Power supply cords should be routed so
that they are not likely to be walked on or pinched by items placed
upon or against them, paying particular attention to cords at plugs,
receptacles, and the point where they exit from the appliance.
12.Object and Liquid Entry - Care should be taken so that objects do
not fall and liquids are not spilled into the enclosure through the
openings.
13.Damage Requiring Service - The appliance should be serviced by
qualified service personnel when:
A. The power supply cord or the plug has been damaged; or
B. Objects have fallen, liquid has been spilled into the
appliance; or
C. The appliance has been exposed to rain; or
D. The appliance does not appear to operate normally; or
E. The appliance has been dropped or the enclosure is
damaged.
14.Servicing - The user should not attempt to service the appliance
beyond that described in the operating instructions. All other serv-
icing should be referred to qualified service personnel.
Precautions:
1. Power – WARNING: BEFORE TURNING ON THE POWER FOR THE
FIRST TIME, READ THE FOLLOWING SECTION CAREFULLY.
All models are designed for use with either AC120V, 60Hz or
AC240, 50Hz voltages. The unit will autoswitch to either of these
voltages.
2. Do Not Touch The A-H1 With Wet Hands – Do not handle the AH-1
or power cord when your hands are wet or damp. If water or any
other liquid enters the A-H1 cabinet, take the A-H1 to a qualified
service person for inspection.
3. Care – From time to time you should wipe off the front and side
panels of the cabinet with a soft cloth. Do not use rough material,
thinners, alcohol or other chemical solvents or cloths since this
may damage the finish or remove the panel lettering.
Source
CONNECTION DIAGRAMS FOR RUSSOUND
Components
CD
"Y" connectors allow each source
5
to be shared with receiver
DVD
DSS
TUNER (or tuner in receiver)
3
ACT-1
Power Strip
CD
2
DVD
Emitter attaches
to each source
DSS
component's
IR window
TUNER (or tuner in receiver)
Pos (+)
110 punchdown connector
on Amplified Keypad
Neg (–)
1
Wire order
® MODEL A-H484. REFER TO THE INSTRUCTIONS ON BACK. DIAGRAMS ARE NOT TO SCALE.
5
S
OURCE
N , NH U.S.A.
EWMARKET
L
R
T O
RIGGER UT
AC 12
VDC
1 2
100mA
S O
YSTEM N
S
4 C -Z , 4-S
OUPLED ONE OURCE
P M A H
ANEL OUNT UDIO UB
A/B C
OUPLED
1 A 2 A
O T
UTPUT O
A K
EYPADS
O T
UTPUT O
B K
EYPADS
1 2
B B
S #
ERIAL
1
A-KP2
RJ45 Wall Plate
(optional)
located
CAT-5
near Hub
(behind wall)
Audio Receiver
8
A-H484
A I
UDIO NPUT
L
INK
IN OUT RJ45 CAT-5
patch cables
3 4
IR
OURCE
C IR
OMMON
-Z O
ONE UTPUT
3 A 4 A
P F
OWER OR
A K
EYPADS
+24V
4A
P F
OWER OR
3 4
B B
B K
EYPADS
A-H484
1 A-PS required for
each row of keypads
RJ-45 Connection Details
Connection shown:
flat side on top
push-clip on the bottom
push-clip
When wiring directly to Amplified Module, use T568A RJ45 wire configuration
A-H484
L
INK
IN OUT
4
A-LRC-1 IR Remote (optional)
6
7
A-PS