Table of Contents
Advertisement
6.2.4
6.2.4
6.2.4
Creating a RAID 1 set (Mirror)
Creating a RAID 1 set (Mirror)
Creating a RAID 1 set (Mirror)
6.2.4
6.2.4
Creating a RAID 1 set (Mirror)
Creating a RAID 1 set (Mirror)
To create a RAID 1 set for Fault Tolerance:
1.
Follow steps 1 to 2 of the C r e a t i n g a R A I D 0 s e t
RAID-1 (Fault Tolerance)
RAID-1 (Fault Tolerance)
2.
Select RAID-1 (Fault Tolerance)
RAID-1 (Fault Tolerance)from the Select RAID Type
RAID-1 (Fault Tolerance)
then press <Enter>.
Refer to the M i r r o r i n g R e q u i r e m e n t s
to determine the number of hard disk drives required for the selected RAID
type.
3.
Use the arrow keys to select a RAID set member, then press
<SpaceBar> to mark. An X X X X X mark appears after the selected HDD.
4.
Follow step 3 to select the other members of the RAID set, then press
<Enter> when finished.
6 - 1 0
6 - 1 0
6 - 1 0
6 - 1 0
6 - 1 0
C r e a t i n g a R A I D 0 s e t
C r e a t i n g a R A I D 0 s e t section.
C r e a t i n g a R A I D 0 s e t
C r e a t i n g a R A I D 0 s e t
M i r r o r i n g R e q u i r e m e n t s note at the bottom of the screen
M i r r o r i n g R e q u i r e m e n t s
M i r r o r i n g R e q u i r e m e n t s
M i r r o r i n g R e q u i r e m e n t s
Select RAID Type
Select RAID Type
Select RAID Type menu,
Select RAID Type
C h a p t e r 6 : R A I D c o n f i g u r a t i o n
C h a p t e r 6 : R A I D c o n f i g u r a t i o n
C h a p t e r 6 : R A I D c o n f i g u r a t i o n
C h a p t e r 6 : R A I D c o n f i g u r a t i o n
C h a p t e r 6 : R A I D c o n f i g u r a t i o n
Advertisement
Table of Contents
