Desa (V)T32N SERIES Owner's Operation And Installation Manual page 24

Direct-vent fireplace ng/lp “tudor” models
Table of Contents

Advertisement

FIREPLACE
INSTALLATION
Continued
REMOvING/REpLACING GLASS
DOOR
CAUTION: Do not operate
this fireplace with a broken glass
door panel or without the glass
door panel securely in place.
For replacement part informa-
tion see Replacement Parts,
page 36.
CAUTION: Wear gloves and
safety glasses while handling
or removing broken glass. Do
not remove if glass is hot. Keep
children and pets away from
glass.
WARNING: If fireplace has
been running, turn off and un-
plug fireplace. Let cool before re-
moving glass door or louvers.
Removing Louver Panels
Remove the top and bottom louver panels by si-
multaneously pulling both top end spring latches
towards the center of the appliance until they are
disengaged from the locating holes (see Figure 40).
Repeat for bottom spring latches and pull the lou-
vers outward. To install or replace items removed,
simply reverse the procedures above.
Figure 40 - Removing Louver Panel
4
Spring
Latch
Louver Panel
www.desatech.com
Removing Glass Door
If replacement of glass is necessary, the entire
assembly, glass and frame, must be replaced. If
glass is broken, wear gloves and tape the remaining
fragments onto the frame.
1. Remove screen assembly by pushing the rod
either left or right and then down and forward
to remove screen/rod assembly from the fire-
box. Set assembly aside.
2. Lift up on latches to unlock. There are two on
top of firebox and two below firebox that hold
glass door in place (see Figure 41).
3. While holding glass door to prevent it from
falling and causing injury, remove the five
screws from the hinge located on the left side
of door frame assembly (see Figure 41).
4. Remount the new frame at the hinge with five
new screws before closing door. This will
ensure seating of the gasket.
5. Close glass door frame. Lock latches by placing
the bar under the tab on door and pushing down
and back on latch (see Figure 41).
6. Replace screen/rod assembly by reversing step 1.
7. Replace louvers by reversing procedure under
Removing Louver Panels.
Unlock
Lock
Screw
Hinge
Glass
Frame
Assembly
Figure 41 - Removing/Replacing Glass
Cleaning Glass Door
See Cleaning and Maintenance on page 30.
Latch
Door
111986-01D

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vt32p seriesT32n seriesT32p seriesChdv32nr series

Table of Contents