Honeywell HZ-510 - Professional Series Ceramic Heater Instructions Manual page 2

HZ-510_OM_Rev1.qxd 6/22/06
IMPORTANT SAFETY INSTRUCTIONS REGARDING THE PLUG ON YOUR PRODUCT
Fig. 1
SET-UP
• Place the heater on a firm, level, open surface free from obstructions and at least 3 ft. (0.9m) away
from any combustible materials. DO NOT use on an unstable surface such as bedding or deep
carpeting. Be sure the heater is not in a position where it may be tripped over by small children
or pets. The heater's rubber feet will hold it firmly in position.
• With the Power knob in the OFF position, plug the heater into a grounded 120V outlet suitable for a
3-prong plug (Fig.1).
OUTPUT DIRECTION
• Turn the Thermostat fully clockwise
This heater is equipped with adjustable front legs that allow you to adjust
the heat output angle up and down.
Adjust the angle up or down by turning the lever located on the side of the
heater counter-clockwise
lower the output angle. (Fig. 2).
10:59 AM Page 2
to its highest position.
to tilt up. Turn the lever clockwise to
Fig. 2