Installing A Half-Height Device - Compaq ProLiant 1850R Setup And Installation Manual

Figure 3-29.
11. Replace the 1.44-MB diskette drive (floppy drive).
12. Replace the server cover.
13. Push the server into the rack and secure it.
14. Reconnect the power cord and power on the server.
15. Reconfigure the server. See to Chapter 5, "Using the System
Configuration Utility," for more information.

Installing a Half-Height Device

To install a half-height removable media device into the removable media bay
area follow the steps below.
1. Remove the desired removable media tray in either bay area A or B. See
the procedure directly above and follow steps 1 through 6.
2. Insert the half-height device into the removable media bay and secure it
with a T-7 Torx screw from the expansion board brace.
Connecting the drive cables
Compaq ProLiant 1850R Setup and Installation Guide
3-27