Table of Contents
Advertisement
2.3
Cooling system
The chassis includes an 8-cm system fan located at the front end of the
PCI cage, and a 12-cm system blower (underneath a metal hood) located
between the PCI cage and the power supply.
The metal hood is held in place by two tabs (one on each side) that rest on
the edge of the PCI cage and power supply, and two hooks attached to the
rear panel.
To remove the 12-cm system blower:
1. Disconnect the fan cable from the connector (labeled FAN1) on the
power interface board.
2. Lift up the inner side (with tabs) of the metal hood and detach the two
hooks from the rear panel edge.
2-4
Metal hood
12-cm System blower
(underneath the meatal hood)
8-cm System fan
Chapter 2: Hardware setup
Advertisement
Table of Contents
