Hard Disk Drives; Installing A Hot-Swap Sata/Scsi Hdd - Asus AP1710-E1 Manual

2.7

Hard disk drives

2.7.1 2.7.1

Installing a hot-swap SATA/SCSI HDD

Installing a hot-swap SATA/SCSI HDD
2.7.1 2.7.1 2.7.1 Installing a hot-swap SATA/SCSI HDD Installing a hot-swap SATA/SCSI HDD Installing a hot-swap SATA/SCSI HDD
If you purchased an AS8, AS4, or AA4 configured model, follow these
instructions to install a hot-swap SATA or SCSI hard disk drive (HDD).
1. Open the front bezel to access the hot-swap drive trays.
2. Release a drive tray by pushing
the spring lock to the right,
then pulling the tray lever
outward. The drive tray ejects
slightly after you pull out the
lever.
3. Firmly hold the tray lever and
pull the drive tray out of the
bay.
4. An empty drive tray requires a metal bracket for support. Use a
Phillips (cross) screwdriver to remove the bracket when you are ready
to install a hard disk in the drive tray.
2 - 1 8 2 - 1 8 2 - 1 8 2 - 1 8 2 - 1 8
M e t a l b r a c k e t M e t a l b r a c k e t
M e t a l b r a c k e t M e t a l b r a c k e t M e t a l b r a c k e t
S p r i n g l o c k S p r i n g l o c k S p r i n g l o c k T r a y l e v e r T r a y l e v e r T r a y l e v e r
S p r i n g l o c k S p r i n g l o c k T r a y l e v e r T r a y l e v e r
C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p