Information To User - Sanyo VCC-XZ600 Installation Manual

Information To User

Be sure to observe the
following
• Be extremely careful when carrying out
work such as drilling holes in order to install
this camera. In addition, pull out cables
such as the power cable and video cable so
that they can be easily routed.
• When installing the camera, take proper
steps to ensure that the ceiling or wall is
waterproof.
• Select a ceiling or wall surface which is flat
and durable and which can support the full
weight of the camera. If installing to a
curved surface or a round pole or similar,
use a commercially-available mounting
bracket to install the camera.
• Install the camera in a place where the
ambient temperature (with power source
connected) is within -20°C - 50°C.
(Condensation should not form.)
• If direct sunlight will shine onto the camera,
install the accessory sunshade.
Precautions
■ In case of a problem
Do not use the unit if smoke or a strange odor
comes from the unit, or if it seems not to function
correctly. Turn off the power immediately and
disconnect the power cord, and then consult your
dealer or an Authorized Sanyo Service Center.
■ Do not open or modify
Do not open the cabinet, as it may be dangerous
and cause damage to the unit. For repairs,
consult your dealer or an Authorized Sanyo
Service Center.
■ Do not put objects inside the unit
Make sure that no metal objects or flammable
substance get inside the unit. If used with a
foreign object inside, it could cause a fire, a
short-circuit or damage. Be careful to protect the
unit from rain, sea water, etc. If water or liquid
gets inside the unit, turn off the power
immediately and disconnect the power cord, and
then consult your dealer or an Authorized Sanyo
Service Center.
■ Be careful when handling the unit
To prevent damage, do not drop the unit or
subject it to strong shock or vibration.
■ Do not install this unit close to magnetic
fields
The magnetic fields may result in unstable
operation.
■ Protect from humidity and dust
To prevent damage, do not install the unit where
there is greasy smoke or steam, where the
humidity may get too high, or where there is a lot
of dust.
■ Protect from high temperatures
Do not install close to stoves, or other heat
sources, such as spotlights, etc., or where it could
be subject to direct sunlight, as this could cause
deformation, discoloration or other damage.
Be careful when installing close to the ceiling, in
a kitchen or boiler room, as the temperature may
rise to high levels.
■ Cleaning
• Dirt can be removed from the cabinet by wiping
it with a soft cloth. To remove stains, wipe with
a soft cloth moistened with a soft detergent
solution and wrung dry, then dry by wiping with
a soft cloth.
• Do not use benzine, thinner or other chemical
products on the cabinet, as this may cause
deformation and paint peeling. Before using a
chemical cloth, make sure to read all
accompanying instructions. Make sure that no
plastic or rubber material comes into contact
with the cabinet for a long period of time, as
this may cause damage or paint peeling.
■ Approvals: IP66/CE
This unit has been certified to IP66 standards
when properly installed.
Use only an IP66 certified enclosure or an
electrical box.
Ensure all openings in enclosure are sealed as
per manufacturer's instructions.
1