Table of Contents
Advertisement
INSTALLATION
Continued
8. Install remote receiver into receiver bracket
using pads and push button clips provided
with receiver (see Figure 20).
9. Connect wires to control valve at the TPTH and
TH locations as shown in Figure 21. Note: Make
sure excess wire does not interfere with burner
or pilot.
10. If heater was removed from fireplace before
installation of remote accessory, see Installing
Heater Base Assembly on page 13 to reinstall
heater into fireplace. Test gas connection for
leaks (see Checking Gas Connections, pages
15 and 16).
11. If logs were removed from heater for install
remote accessory, replace logs (see Installing
Logs, pages 18 and 19).
Push Button
Clips
Figure 20 - Installing Remote Receiver
White Wire
From Receiver
Red Wire From
Receiver
Figure 21 - Connecting Wires
112882-01D
Control
Valve
www.desatech.com
17
Advertisement
Table of Contents
