Samsung SRD-1650DC User Manual page 48
8 channel, 16 channel dvr
Hide thumbs
Also See for SRD-1650DC:
- Specifications (2 pages) ,
- Specfications (1 page) ,
- User manual (134 pages)
Table of Contents
Advertisement
•
Duration : Sets the alarm duration for the alarm signal and beep sound.
- Check Alarm, Replace Alarm signals will output through the selected alarm out ports (1, 2, 3, and 4).
- If <BEEP> was selected, a beep will sound.
- If <All> was selected, both beep sound and alarm signal through rear side ports will output.
M
<Check> status means that the HDD is operating but it has problems that require technical examination.
(
) appears on the Live screen.
<Replace> status means that the HDD has defect and requires immediate replacement.
(
) appears on the Live screen.
6.
When the HDD Alarm setup is done, press <OK>.
Remote Devices
You can set the RS-485 communication for use of PTZ Camera and system keyboard with the DVR.
Using the mouse may help make setup easier.
3.
Use the up/down buttons ( ) in <Device> window to
move to <Remote Device>, and press [ENTER] button.
Use direction buttons ( ◄ ►) to move to the desired
4.
item, and press [ENTER] button.
5.
Set the values of each communication setup of the remote
device.
•
Baudrate : Baud rate settings of the DVR, PTZ camera and
system keyboard should be matched for proper operations.
6.
Make sure to match IDs of the DVR, System Keyboard
and Remote Control, and press <OK>.
M
For changing the remote control's ID, refer to "Changing the Remote Control ID". (Page 13)
POS Devices
You can set properties of POS devices connected to the DVR.
A POS device connection requires channel, preset, and Port/Ethernet settings.
Using the mouse may help make setup easier.
3.
Use the up/down buttons ( ) in <Device> window to
move to <POS Device>, and press [ENTER] button.
Use direction buttons ( ◄ ►) to move to a desired
4.
item, and set the value.
•
POS USE : When selected <POS USE>, DVR and POS will
be connected.
J
If you change settings for the device and press <OK> while
the <POS USE> is not checked, the changes for POS device
will not be saved.
48_ using the DVR
Remote Device
Baudrate
Parity
Data
Stop Bit
9600
None
8
1
System Keyboard
OFF
ID
00
Remote Control
ON
ID
00
OK
Cancel
POS Device
POS USE
POS
CH
Preset
1
None
No preset
2
None
No preset
3
None
No preset
4
None
No preset
5
None
No preset
6
None
No preset
7
None
No preset
8
None
No preset
OK
Cancel
Transfer type
Half Duplex
POS Device Setup
Port/Ethernet
None
None
None
None
None
None
None
None
Previous/Next Page
- Quick Links:
- Connecting the Network
Hide quick links:
Advertisement
Table of Contents
