Connection; Connecting To Power; Connecting To 8P Control Terminal - Samsung SDZ-370 Series User Manual

Connection

Connecting to Power

DC Power Type (DC 12V, 500mA)
Use DC 12V/500mA power source for SDZ-370N/P.
Notes
• Connect the power once the installation is complete.
• The wire is polarized. Match '+' and '-' terminals properly.

Connecting to 8P Control Terminal

The camera can be controlled by using external controllers like a Remote controller.
(RS-485 Communication)
SCC-3100A
SCC-101
* 8P Control Terminal Configuration
Number Name Cable color Description Number Name
1 ZOOM ORANGE 5
2 FOCUS WHITE/ORANGE 6
-
3 COM GREEN 7
4 MD OUT WHITE/GREEN 8
12
COLOR CCD CAMERA
Power Input Terminal
8-Pin CABLE ASSY
Cable color Description
GND BLUE -
EX DN WHITE/BLUE External D/N
485+ BROWN RS-485 communication
485- WHITE/BROWN RS-485 communication
User's Manual
Connector Function
Tele
ZOOM
Wide
Far
FOCUS
Near
COM
MD
0V
There is no motion
DAY mode: D&N terminals must be OPEN to external signals.
EX DN
(Do not input voltage)
NIGHT mode: D&N terminal must be connected to the ground
Notes
• MD(Motion Detection) Output Signal Level(less than 10mA)
• When using the MD function, the 'GND' should be connected to the frame ground.
• D o not simultaneously connect the RS-485 (+) (-) communication line when you use
voltage control ZOOM and FOCUS, using the RECEIVER BOX (SRX-100B).
* Match the communication setup between devices when you use the wired controller
(SCC-101) or SCC-3100A.
ITEM SCC-101(fixed) SCC-3100A(Factory Default)
MODE Serial Serial
Data Bit 8 bit 8 bit
Bit/Sec 9600bps 9600bps
Parity EVEN NONE
CAM ID NO. 0 1~255
RETURN PACKET ENABLE See the SCC-3100A manual
COLOR CCD CAMERA
Signal Level I/O
+6V ~ +12V
COM
I
COM
- 6V ~ -12V
+6V ~ +12V
COM
I
COM
- 6V ~ -12V
-
COM
+3.0V
O
5±0.5sec
There is motion
← →
I
Notes
• C ontact an authorized
technician for
inspection.
13
User's Manual